Electronics Forum | Thu Nov 14 18:51:08 EST 2013 | tombstonesmt
We use a 2mm with our Pillarhouse Jade Mark II. We found that reducing the nitrogen enough that the area around the nozzle stays hot enough not to "freeze".
Electronics Forum | Tue Oct 21 09:36:50 EDT 2014 | island2013
Hi Bill, Yes it does have a small circuit right behind the plate. There is a 2amp fuse in there along with some other circuitry. Perhaps your fuse went out
Electronics Forum | Fri Aug 07 05:12:02 EDT 2015 | emanuel
According to the manuals there is a 2D solder paste inspection mode on these machines. If anyone is using this option, please share the setup details. Thanks
Electronics Forum | Sun Sep 25 14:26:41 EDT 2016 | mrpackethead
Im looking for manuals for theYV100-2 and YVL88 machines, as i have just bought a 2nd land line at auction. Does anyone have one, or know where i can get one from?
Electronics Forum | Mon May 08 10:10:27 EDT 2017 | dontfeedphils
For anyone looking this up in the future, I ended up settling on part number "A-2-3.5", an aluminum, smooth finish coupon, 0.025" thick x 2" x 3.5".
Electronics Forum | Tue Sep 11 04:39:14 EDT 2018 | cannizzaro
If you need to know the exact copper thickness of the board, you can ask the Fab to offer the microscopic report, I have already made a 2oz board in ALLPCB before and asked them offeed me this report,usually normal factories can offer it but need add
Electronics Forum | Fri May 18 08:21:02 EDT 2018 | mahendra
Hello, please advise me if you have or know of anyone selling a 2nd hand pick n place machine. Machine must be in South Africa. Thank you kindly.
Electronics Forum | Thu Jul 12 05:20:01 EDT 2018 | robl
We had the same issue recently, we swapped to a 2 part shield to allow AOI and SPC xray. We also tested using silver epoxy and putting a one piece can down after inspection. That worked too.
Electronics Forum | Wed Jan 09 15:21:50 EST 2019 | dontfeedphils
Large and small levels, chalk line, plumb bob, pallet jacks, johnny bar, a 2x4 + sledge hammer, and a couple of the same PCBs to test transfer between machines.
Electronics Forum | Thu Aug 08 10:32:30 EDT 2019 | SMTA-Joe
Ok, interesting. Unfortunately I can't speak on that. We always treat these as a 2nd ops and have never had a problem. We determined it was something that could add to thermal trouble. Also, the amount of solder added during paste deposition may not