Electronics Forum | Thu Aug 01 19:03:30 EDT 2013 | joeherz
I am sick of Kapton. We have varying levels of leftover residues on multiple brands and I'm done chasing this thing. We have tested some wave tapes that were total garbage in years past. Really don't want to go there. Peelable liquid masks - Who
Electronics Forum | Mon Aug 21 19:38:33 EDT 2000 | Dave F
Eric: I�ll pass on the uV and ammonia, also. Thoughts are: 1 You�re correct that the temperature/humidity mix can be a big driver to latex peelable solder mask cure time, but don�t overlook material thickness. Dispensers put material in a very th
Electronics Forum | Mon Jan 26 07:27:43 EST 2004 | loz
I have a product that has earthing/positioning holes, as they are to be used for earthing purposes they need to be free from conformal coating. This pcb is double sided. I have used spot/peelable mask to protect these holes. However when the conforma
Electronics Forum | Fri Feb 20 17:04:26 EST 2004 | Long
Hi I am looking for some type of peelable mask or plug to cover the connector during the conformal coating. The problem we have is the moisture get into system and eventually penetrate under the connector creating short circuit to the board. What I r
Electronics Forum | Wed May 26 03:04:09 EDT 2004 | johnwnz
Mark, that would be a good report to have a look at can you post it on the site or mail it out to me? Also I've been having an issue with blue peelable solder mask on silver boards where it peels the silver off with it. I've only seen this since my v
Electronics Forum | Tue May 10 15:27:36 EDT 2005 | amejia
We actually did try dots, 1/8" to be exact. We found that they were hard to peel off using just your fingers. Also, the manufacturer punched the dots too deep and ended up going through the backing on many of them. However, using tweezers, it didn
Electronics Forum | Tue Jan 17 16:43:03 EST 2006 | davef
If you are not washing and want to stay with a peelable mask the two basic types are vinyl and latex. Although we've seen some silicone and urethanes, they cost more. * Do not use latex peelable solder mask with a low residue soldeing process withou
Electronics Forum | Thu Oct 17 00:34:59 EDT 2019 | jani
Hi, We have solder reflow use with water soluble flux and Tin/lead process. There is special glass component which needs to mask during reflow soldering and wash flux+solder mask post soldering. The existing solder mask does washes off. But leaves
Electronics Forum | Tue Mar 21 20:33:09 EST 2000 | Dave F
Shane: We don�t dispense, but we have thought about it. Several points about peelable solder masks in a no-clean (low residue) process: � Beware of latex peelable solder mask with a low res process without extensive testing. The problem is usuall
Electronics Forum | Tue Dec 14 11:17:45 EST 1999 | John Thorup
Hello Mike You'll have to be a bit more specific. Do you mean permanent solder mask like the normally green material or a temporary mask like the peelable/washable material? John Thorup