Electronics Forum | Tue Jun 15 22:31:06 EDT 2010 | Mag10
Depending on the how you plug the via, the void level can significantly affected. If you have via plugged from the bottom side; i.e. opposite side of the component, you will see alot of void due to entrapped air in the via hole. I found work best wh
Electronics Forum | Tue Aug 23 22:50:09 EDT 2005 | adeline_ko
My process guy told me that. Due to black spot issue, brd with BGA must use electrolytic finishing. And when we had this finishing with plug via, the blister issue pop out. My supplier claim that this is due to the plug via. Which I don't know how
Electronics Forum | Wed Jul 23 08:18:29 EDT 2008 | davef
Q1. Is this a standard process for plugging? A1. Not as such. We checked both IPC-6012 and IPC-SM-840. Neither comments on plugging. So, your fabrication notes rule the day. Q2. Is this okay for such thick PCB's or is it mandatory to use a special pl
Electronics Forum | Mon Jan 11 14:48:44 EST 2010 | davef
SR1000 is commonly used for tenting. Search the fine SMTnet Archives on : tenting Someone gave us this note. We have lost their name. It seems to be good advice. If Liquid Photo Image (LPI) solder mask is required, do not tent via holes. Tenting
Electronics Forum | Tue Mar 22 20:33:24 EST 2005 | davef
Q1. What are you guys doing for filled/tented/plugged vias on the BGA site? A2. 2221A, 4.5.1 tells you the vias have to be tented on both sides. Q2. What type of issues can this cause if using no filled/tented/plugged vias on the BGA site? A2. BGA
Electronics Forum | Wed May 19 13:13:20 EDT 1999 | Dave F
| We care currently running into problems during our plug via process: | At the moment we plug prior to soldermask (LPISM) using epoxy resin - plugging takes place from the component side - however we are seeing solderballs after solder level.This is
Electronics Forum | Tue Mar 05 22:34:27 EST 2002 | YoYo
You better be careful how you plug vias at screenprint - we currently have a customer that wants vias plugged, so we had a 2% aperature reduction so we would not have to much paste, I believe it should have been reduced more because some of the solde
Electronics Forum | Wed Jul 07 09:47:41 EDT 1999 | Peter Brant
| | Q #1) Is it more reliable to have the mask tent over the vias or risk getting vias half filled with solder? These are vias with an .020" hole and .040" or .050" pad. WIth regards to this question, and scott's follow up, I have used the "epoxy me
Electronics Forum | Tue Nov 27 14:24:13 EST 2001 | mparker
Short term fixes can be: have the vias "plugged" with solder by the fab house. This works if your fab is HASL finish. Tent the vias with solder mask, top side only. You may get a flux entrapment issue in the vias with this manner. Long term fix can
Electronics Forum | Thu May 20 07:53:55 EDT 1999 | Chris Nuttall
| | We care currently running into problems during our plug via process: | | At the moment we plug prior to soldermask (LPISM) using epoxy resin - plugging takes place from the component side - however we are seeing solderballs after solder level.Thi
.gif)
