Electronics Forum | Fri Feb 25 04:28:49 EST 2000 | Sze-Pei LIM
We faced terrible void issue while using Sn96.5Ag3.5 solder paste, more than 20% void. We tried adjusting the reflow oven profiles but we did not have much success in reducing the void. Generally, we find quick preheat, high peak temp. and fast cooli
Electronics Forum | Wed Feb 28 19:44:50 EST 2001 | pzohbon
I am having problems with voids in our soldering process. I believe it to be the fact that we use a no clean flux without control on how the boards are handled (gloves, procedures, etc.) Does anyone have suggestions on the appropriate place to start?
Electronics Forum | Thu Mar 01 11:43:08 EST 2001 | dason_c
Not enough info, when you say no clean flux, is it for wave soldering process, please provide more detail, SMT or wave, is it all the joint which you find the void? Rgds
Electronics Forum | Thu Apr 17 13:02:28 EDT 2003 | Takfire
Thanks Dave! What level of voiding is acceptable? Would you please let me know if there is an EIA or other industry standard detailing solder joint quality? I will begin researching the background information you provided. Thanks again for your kin
Electronics Forum | Thu Nov 01 10:57:34 EDT 2012 | kris1128
Has anyone heard whether the elevation of a plant can effect solder joint formation? One plant at sea level, one at 7,000 feet elevation... same equipment and profiles, big voiding defects at higher elevation. I did a search and found no similar post
Electronics Forum | Mon Sep 28 12:55:37 EDT 1998 | Manish Ranjan
Hi Everyone Does anyone has any insight regarding the void formation in the solderbumps during wafer bumping by electroplating. Someone told me that it could be mainly coz of the alloy concentration being incorrect. Any suggestions, corrective action
Electronics Forum | Wed Apr 16 13:19:13 EDT 2003 | Takfire
Thanks Russ! The origianal complaint from the customer was in regards to what appeared as "bumpy" appearance and "holes" in the solder fillet. This problem was originally presented as an appearance issue only. Further investigation by our DPA lab r
Electronics Forum | Wed Apr 16 10:45:16 EDT 2003 | Takfire
Recent cross-section analysis for a customer complaint revealed voiding in the solder fillet. In some cases, the remains of outgassing were also observed. During the failure analysis, we also observed failures where the solder fillet wicked on the
Electronics Forum | Thu Apr 17 16:43:09 EDT 2003 | davef
Background: * Bulwith, Ronald A., �Failure Analysis of Solder Joints�, �Insulation/Circuits� magazine, February 1978 * Banks, Donald R., et al., �The Effects of Solder Joint Voiding on Plastic Ball Grid Array Reliability�, Proceedings of the Technica
Electronics Forum | Thu Apr 17 18:18:34 EDT 2003 | davef
We undoubtedly will take you up on that offer. Please email contact information.