Electronics Forum | Fri Feb 01 07:21:32 EST 2019 | dfl
One of my 8mm feeders is blinking the red led after the pick-up. With both buttons the motor works as expected (forward/backward), but after the nozzle pick-up the motor moves forward and then the red led blinks. pressing the buttons the green led l
Electronics Forum | Sat Feb 02 09:53:49 EST 2019 | slthomas
Commponent pitch programming is performed via the buttons on the feeder. I don't remember enough to walk you through it but there are people here that do - I'm sure you'll get some help shortly. If not, go to http://www.precision-repairs and use th
Electronics Forum | Sun Feb 03 08:46:34 EST 2019 | dfl
SOLVED The LED/phototransistor was a little of the center on the "index wheel" (don't know a better name, its the gear that pulls the component strip). The wheel works with a LED from one side and a phototransistor from the other, through a hole on
Electronics Forum | Sun Feb 03 09:36:29 EST 2019 | bobpan
Good job.... Sorry i didnt see this post...some of us were busy snow tubing over the weekend...haha. Many times over the years....the rubber belt inside the feeder will deposit material inside. Sometimes it ends up on the sensors and blocks the ligh
Electronics Forum | Sun Feb 03 07:36:17 EST 2019 | dfl
Hey Steve, I wrote to Bob, but he doesn't reply yet. Digging around, I found these: HANDLING COMPONENT VARIETY The adjustable Pocket Index function enables handling a variety of component tape reels or special component packaging. The following ins
Electronics Forum | Sun Feb 03 07:39:27 EST 2019 | dfl
POCKET POSITION PROGRAMMING This procedure ensures the components are properly centered at the tape feeder pickup point (over spring stabilizer). NOTE: The feeder can be reset at any time by removing it from the feeder base and reinserting it. This
Electronics Forum | Mon Jun 20 18:36:42 EDT 2005 | jsloot
Does anyone have any experience with a QUAD Meridian 1010? Our company has purchased a used machine. We have it installed and running almost smoothly. Getting an error code 3487, description is "Z axis target position in motion board is strange" Anyo
Electronics Forum | Mon Jun 16 10:52:02 EDT 2014 | robstarrs
bobpan quick background. I am very new to the Quad machines, I used to "run" one, but I never learned the inner workings of a machine. I just purchased 2 used quad 4cs, I had a training session over the weekend with a very knowledgeable guy and l
Electronics Forum | Thu Dec 29 04:19:52 EST 2005 | lvqp72
We've run into a persistent QA error 99 on one of our Quad IVC's. Have checked upon all the obvious and found no bad components. Do appreciate any advice on this problem. Thanks.
Electronics Forum | Wed Apr 10 15:05:23 EDT 2013 | microaide
I followed your instructions and did NOT select the option to break up the program for separate central controllers. I now have a program I can copy to central controller #1, and I can delete the head 2 data from the program. Now when I select RUN TH