Electronics Forum | Thu Jan 29 23:07:37 EST 1998 | Scott
| We are facing some placement problems with | our QUAD 4-C. | Program was running fine last week, Next week | program will be off (placement, pickup,vision files | etc, | Any help, any idea,??? | Thanks I had the same problem on a trio of Quads at m
Electronics Forum | Thu Jul 31 03:20:29 EDT 2008 | miroyu
Hi everyone I have Quad 4C with following problem. When I run machine "cold start" first power up it will run and initialize but after if I turn it off and back on it will NOT initialize. Z axis will push nozzle down and it will remain i that posit
Electronics Forum | Wed Nov 23 14:37:58 EST 2016 | tnisbet
Good day > > I would like to know if the Quad 4C > keeps a register of rejected components in a > certain period of time, like " X components > rejected from feeder Y" or something like > that. > > Thank you so much Adam - The Quad 4C Window
Electronics Forum | Mon Jun 19 09:47:01 EDT 2017 | dleeper
Quad made an auger style dispenser that mounted to the pick and place head. A long time ago, in CM far far away, I tried to add one to a Quad 4C but could never get the damn thing to work. The folks at PPM http://www.goppm.com/ might be able to he
Electronics Forum | Mon Jun 19 09:53:27 EDT 2017 | tnisbet
Hi, Yes you can add a paste dispenser to the Quad 4C. The system will dispense DOTS and DOT patterns, no lines. We sell kits to add the dispenser. It takes about 4hours to install the kit. We also sell Camalot dispensers, benchtop & floor models. w
Electronics Forum | Fri Jul 19 16:27:38 EDT 2013 | microaide
I think I have the vision problems figured out. There were two problems. 1) The Alignment type was set to "Small" for my TQFP48 part. It should have been set to "Complete". This is a clear case of poor documentation. The AutoProgram manual lists the
Electronics Forum | Thu Sep 22 13:05:29 EDT 2016 | chabscan
Hi I would like to know the process in wich the Quad 4C knows it has the correct component after taking it from the feeder. Recently I've been put in charge of a Quad 4C machine that is used to assemble two different boards. Each one has already a
Electronics Forum | Wed Feb 25 03:01:13 EST 1998 | MARK EDVINSSON
| We are facing some placement problems with | our QUAD 4-C. | Program was running fine last week, Next week | program will be off (placement, pickup,vision files | etc, | Any help, any idea,??? | Thanks To be honest with you those machine they never
Electronics Forum | Wed Aug 28 21:47:22 EDT 2013 | nophsem
HI! We have a QUAD 4C since 8 months . Yesterday the head remained immobile in the position where it put the last component to complete a board and indicates Motor Error # 5 (SRX engine communication time-out) and I don’t know what it means and ho
Electronics Forum | Fri Aug 30 11:31:29 EDT 2013 | nophsem
We have two QUAD 4C working in tandem. 3 months ago the EPCU battery (QUAD # 2) died, then we change it. Then downloaded the MODs from the controller to the assembler(does simultaneously on both machines). All this time we continue to work normally.