Electronics Forum | Mon May 06 14:55:58 EDT 2013 | dyoungquist
We had that problem on our M12. There were a few components that had gotten dropped into the camera area as the hydra head past over it. Our MY12 has a knob towards the front of the machine in direct line with the camera. Pulling this knob release
Electronics Forum | Wed Jun 17 01:02:16 EDT 2015 | armandogomez
Hello Had a similar problem way back with the hydra, first go to the service program manually activate the hydra camera then move the Xwagon to place the hydra ref plate over the hydra camera and check first if the camera works, second the image you
Electronics Forum | Mon May 06 19:21:39 EDT 2013 | amelby
We had that problem on our M12. There were a few > components that had gotten dropped into the > camera area as the hydra head past over it. Our > MY12 has a knob towards the front of the machine > in direct line with the camera. Pulling this
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Mon Jun 19 09:15:46 EDT 2006 | heatherc
The CircuitCAM product that Dave referred to below is sold by Aegis Industrial Software. They can supply you many references from the 250+ sites using the software to program the Mydata as well as sites utilizing the Orbotech equipment programming f
Electronics Forum | Wed Feb 10 07:50:52 EST 1999 | michele sommaruga
I am referring to reflowing twice. Fist time I reflow the up side, turn the PCB and reflow the bottom side. | By double reflow are you referring to double sided reflow? Or are you referring to reflowing twice? | | | | I would like to have informat
Electronics Forum | Mon Oct 13 01:28:37 EDT 2008 | kywl
Hi, I would like to ask if there's a guideline/specification on what is needed to qualify a new SMT automated assembly line? Is there any standards i can refer to? IPC or JEDEC? Is there a reference number for the standards so i can refer to as we
Electronics Forum | Thu Sep 24 04:49:45 EDT 2009 | d0min0
that crossed our minds - overloading of the oven but in reality we produce 5 references with very little output difference (close to 2 sec difference) so it should be a problem since a few yeats and on all references...? no only on 2 references from
Electronics Forum | Thu Jun 15 14:14:18 EDT 2017 | pfuhrman
I have seen a few references in this forum to an old study (1980s?) by Roger Wild at IBM. But I cannot find a published report or usable reference to one. davef mentioned the SMTnet archives as a possible source, but that has also been a dead end.
Electronics Forum | Wed Mar 04 20:39:18 EST 2009 | kircchoffs
thermistor