Electronics Forum | Wed Jun 29 03:23:10 EDT 2005 | dougs
We used to use a company in the uk that did this, we stopped as the results were never that good, i think the company stopped offering the service as well as no-one else wanted to have their nozzles repaired, it's best to get new nozzles in and make
Electronics Forum | Wed Jun 29 03:47:12 EDT 2005 | fastek
I'm confused. Aren't Fuji nozzles like $20 each? Why bother? I would hope you understand that a nozzle not properly repaired could cause $50 worth of rework in about a minute after you installed it. Stepping over dimes to pick up pennies comes to min
Electronics Forum | Fri Apr 29 07:29:58 EDT 2005 | siverts
Steve, Thanks for Your replay and I agree with You. But sometimes I find it hard to always have the optimum in every aspect of our high mix/low volume electronics assembly production. We also do a lot of prototype production. In this case we had to g
Electronics Forum | Thu Apr 02 12:21:56 EST 1998 | Justin Medernach
| I am looking for a product to repair PCB mask (seal exposed copper) and fill Gouges in pcbs, any suggestions? Mike, They sell all sorts of reparation kits for this type of problem. Liquid mask can come in many forms. The easiest to use is probabl
Electronics Forum | Sun May 29 15:12:46 EDT 2005 | Philippe
I have been following this thread with a great interest. However, the rules or legislations that control RoHS standards is maybe questionable, but I can't see why people/companys have so hard to think about the "next generation"? The fact is: RoHS is
Electronics Forum | Sun Jun 12 15:45:12 EDT 2005 | Olof
Hi, We have just recently ordered a pre-heater for repair. Our concerns is: What temperature shuld we working with? I reckon that it shuld/must be between 80-100 degr. Celcuis? And also; How are we dealing with the MS-level (RoHS compliant) componen
Electronics Forum | Mon Apr 17 19:44:20 EDT 2000 | Dave F
Ashok: Well, your customer probably has a good reason for wanting you to send them boards without holes in the solder mask. What is their goal for the mask capabilities after you get do reworking the boards? * Cosmetic surface coat? * Performance t
Electronics Forum | Sun Jul 15 12:34:15 EDT 2001 | clktsh88
There is a equipment brand : Martin is capable to do you want. In US you may try to approach Manncorp for it. Bye
Electronics Forum | Sun Jul 15 12:34:32 EDT 2001 | clktsh88
There is a equipment brand : Martin is capable to do you want. In US you may try to approach Manncorp for it. Bye Chng LK
Electronics Forum | Sun Jul 15 12:34:43 EDT 2001 | clktsh88
There is a equipment brand : Martin is capable to do you want. In US you may try to approach Manncorp for it. Bye Chng LK