Electronics Forum | Wed May 27 14:35:52 EDT 1998 | Justin Medernach
| | R&D is currently designing a board with smt components on both sides of the board. They are adding a 16 pin IC Gull wing. on the bottom side of the board. I have asked for only caps and resistors to be placed on the bottom side. Is there a recomm
Electronics Forum | Wed May 27 13:42:08 EDT 1998 | Chrys
| R&D is currently designing a board with smt components on both sides of the board. They are adding a 16 pin IC Gull wing. on the bottom side of the board. I have asked for only caps and resistors to be placed on the bottom side. Is there a recommen
Electronics Forum | Tue May 24 07:51:43 EDT 2022 | spoiltforchoice
Doesn't exist. True Solder Paste dispensing is a Mycronic only solution with Essemtec coming behind with slightly less cpapbility. With Essemtec you can have one machine that prints and places, that saves space, with Panansonic you can have machines
Electronics Forum | Tue Mar 07 21:35:16 EST 2006 | Cal Kolokoy
Samir, From experience, the only board test situation where tented via's have difficulty with contact is with a Flying Probe type tester. Otherwise, for traditional ICT, the force of the pogo pins, correct probe type, and fixture design should do th
Electronics Forum | Fri Mar 26 11:31:34 EDT 2010 | rway
I have been using ICT for a number of years. It is still a viable resource for catching defects in the production process. AOI doesn't catch everything, such as bridging on QFN or J-lead devices (this will depend on the type of AOI and camera syste
Electronics Forum | Fri May 23 18:55:20 EDT 2008 | gregoryyork
This is one of the biggest mistakes with the Lead Free process. We have all listened to the 'industry experts' and followed their advice and unfortunately got it wrong. Keep the dwell times (dependant on alloy selection) the same as Leaded so you are
Electronics Forum | Mon Jan 10 18:35:05 EST 2011 | eadthem
Ive used a Mirtec machine for 3 years MV3L with side angle inspection. Mirtec has some issues documentation, and repair plus. But there machine is impressive and the AOI software is good. We can find about 90-99.99% of all errors using just the 5
Electronics Forum | Fri Jul 23 13:09:48 EDT 1999 | Steve
| There is a practise within the industry of an Inspector inspecting a board, and that same Inspector performing touch-up. My opinion is that the Inspection and Touch-up operations should be separate functions whereby the Inspector is not performing
Electronics Forum | Thu Aug 31 09:13:13 EDT 2023 | tommy_magyar
Is there any outcome?
Electronics Forum | Mon Aug 14 01:29:49 EDT 2023 | calebcsmt
I have noticed on a recent project, the QFN and SOP solder deposits do not seem very uniform and have been leaving little balls, whiskers and icicles of solder paste coming from some pads which leads to bridges. https://imgur.com/a/lqw5RF1 I have u