Electronics Forum | Fri Dec 08 23:02:24 EST 2000 | LeeKibler
Beware the foam fluxer. I had a problem with cracked caps that just about drove me off the deep end. I discovered that my foam fluxer air knife was not turned on resulting in excessive flux. The excessive flux (VOC free) was not properly dried off
Electronics Forum | Tue Aug 31 20:51:20 EDT 1999 | Raeto Zryd
Dear fellow process engineers, Some solder joints "trough hole component" have cracked. I suspect that in the market some technician tryed to straighten some components (LED) and has applied enough force to actually brake the joint. The joints were
Electronics Forum | Wed Sep 01 13:48:29 EDT 1999 | Dave F
| Dear fellow process engineers, | | Some solder joints "trough hole component" have cracked. I suspect that in the market some technician tryed to straighten some components (LED) and has applied enough force to actually brake the joint. The joints
Electronics Forum | Wed Oct 17 10:21:08 EDT 2001 | genglish
Cheers guys for your rapid response, I investigated the problem further today, eventually I cam round to curing the adhesive in a sandwich of microscope slides resting on the PCA in question (hopefully mimicking the heat transfer), the adhesive is sp
Electronics Forum | Sat Apr 26 20:27:18 EDT 2003 | LWEI
I'm working on a protobuild for a pcba. THis pcba uses double-reflow, paste-in-hole process. On bottom side there is a Ceramic BGA, size 35 X 35 mm, thickness 6mm, over 900 balls count (ball pitch 1mm)and it weighs a hefty 20 grams. Printing uses 6 m
Electronics Forum | Fri May 07 15:37:22 EDT 1999 | JohnW
| This is not strictly a surface mount query but any input welcome | I am thinking of using surface mount solder thief pads for a through hole connector. The connector is two rows of 0.1" pitch pins and on waving there is often a bridge on the last t
Electronics Forum | Thu Dec 03 21:40:01 EST 2020 | itmconsulting
Hey Kyle - Good for you for pushing your horizons and considering pin-in-paste (aka "Intrusive Soldering"). Don't let the nay-sayers out there discourage you. When I encounter mixed tech PCBAs (SMT and through-hole) my first choice, if the design a
Electronics Forum | Thu Sep 23 17:31:12 EDT 1999 | DaveH
For another excellent vendor try EMC GlobalTechnologies in Pennsylvania (215)340-0650. Contact Marty Wetzel. | | | | | | any thoughs? | | | | | | thanks | | | | | | | | You should use pallets that stand the reflow as well so that no separation wi
Electronics Forum | Thu Sep 02 14:42:52 EDT 1999 | JohnW
| We are assembling double side pcs reflowing (smt) on top and by wave on bottom. | After first step (smt) we dispense glue on the bottom side putting one or two glue dots under small components and we cure in oven before wave. | After wave solderin
Electronics Forum | Tue Sep 07 12:51:02 EDT 1999 | Brad Kendall
| | We are assembling double side pcs reflowing (smt) on top and by wave on bottom. | | After first step (smt) we dispense glue on the bottom side putting one or two glue dots under small components and we cure in oven before wave. | | After wave so