Electronics Forum | Thu Jun 12 00:27:29 EDT 2014 | jasmine01
How to limt my Cisco WS-C3560X-48T-S switch port to 128kb which running 12.2(55)SE3 ? Could anyone help with the IOS commands needed to achieve this ?
Electronics Forum | Wed Aug 20 13:03:57 EDT 2014 | vipin_nmt
Triple Lane NXT Modules cannot be used for Single Lane and had PCB limitation of 250 x 170 mm only. do we have any solution.
Electronics Forum | Mon Dec 06 14:59:37 EST 1999 | Brian W.
Cpk is sometimes referred to as the voice of the process because it is measuring how tight your process is in relation to the specification limits. A Cpk of 1 means that you are running a 3 sigma process (plus or minus 3 sigma). This means that you
Electronics Forum | Mon Mar 10 15:52:26 EST 2003 | eagle-eyed-one
Hello Neil, I absolutely agree with the conclusion of limits as you have stated. There are 2 sets of limits in which machines can be measured against for compliant performance. First and most critical being the quality performance specification limit
Electronics Forum | Fri Sep 24 10:43:42 EDT 1999 | Ken Kkoyen
| The machine is a Universal 6796 DIP inserter. The driver card for the X axis burned a couple of resistors and a trace, probably a couple of power transistors too. I had a spare card and put it in. Now on powering-up the machine, the X-Y table mo
Electronics Forum | Tue Feb 12 11:26:31 EST 2019 | aldrich17
Does anyone have any info. on an "E869" error code on a Phillips Topaz X SMT machine. Error screen shows "Nozzle down limit sensor is off in A-table YV100X:N2323 YV100XT:n2223 Please check sensor and remove to the cause of this sensor being off.
Electronics Forum | Tue May 10 09:45:53 EDT 2011 | veeckm
After changing mod codes 50,51 and 54,55 respectively on the HHT I will then goto ccconfig.sys file in the central controller software and manually enter in the new mod code values. I do not do any uploading/downloading of mod codes through database
Electronics Forum | Thu Mar 24 23:34:55 EDT 2022 | glasscake
My Koh Young 3030VAL errors on the homing routine. The "DTool" "MCS" gives me an error "Before homing, X-AAxis already checked negative limit..." "Before Hoking, Y Axis already checked negative limit..." "Please turn off the control-power-switch, an
Electronics Forum | Fri Jun 01 22:49:50 EDT 2007 | mika
These ones from ALTERA the QFFP-304 0.5mm weight: 32gr. used to give us a really headache in the past. Not only soldering issue:s but also the placement in x-y-theta! The stencil thickness of ours is 0.13mm and because of ohter compomponent packages,
Electronics Forum | Wed Mar 20 19:53:11 EST 2002 | davef
Your customer's question is reasonable. Before you can establish your control limits, you need to take 25 to 30 data samples of 4 to 5 measurements. This says you need a 100 or more measurements before you can start charting. And even this much