Electronics Forum | Mon Nov 25 20:52:47 EST 2019 | cbeneat
Are the arms pulling the cart all the way in? Possible part blocking the limit switch. does the cord have power? If I remember correctly, we once had to adjust the mechanical stops on one of ours so it would make the switch.
Electronics Forum | Mon Aug 08 07:45:23 EDT 2011 | geb
Although I don't have the same model machine (ours is Samsung CP45FV) our Vib feeder had a "transportation" screw or strap (it was a few years ago) fitted that you need to remove before it vibrates properly. Ours has a on/ off switch on the feeder
Electronics Forum | Fri Sep 18 05:10:07 EDT 2015 | bobpan
Hello Simon, I would check to make sure the covers are closed and the cover switches are working. Make sure an e-stop is not pressed. After that....I would check the contactors in the rear of the machine. I have had the contacts on the insides of som
Electronics Forum | Tue Aug 05 12:05:20 EDT 2003 | dougt
It looks like I could setup a UPS on this machine one of two ways. The first would be a 3 phase, 208V UPS in series with the machine (sounds big and expensive). The second is a single phase 208V UPS to just the 2 computers. I have a safety concern
Electronics Forum | Fri Jan 12 11:46:26 EST 2018 | emeto
I don't know this exact oven, but usually it goes like that: First is a three phase power, then it is a contactor that is switching the power for the heaters and fans. than there are transformers for lower voltages. then there might be UPS system in
Electronics Forum | Thu Oct 04 00:05:25 EDT 2018 | gaintstar
Flason SMT chip mounter Reflow Ovens: http://www.flason-smt.com/product/PCB-assembly-line-equipment-SMT-spare-parts-Dek-Motor-188962.html http://www.flason-smt.com/product/PCB-Conveyor-for-LED-Production-Line-SMT-Assembly-Line.html http://www.flason-
Electronics Forum | Tue Apr 23 07:40:30 EDT 2019 | kayvee
Check the E-stop switches are not latched in, I have noticed you get weird startup errors if they are.
Electronics Forum | Wed Oct 10 09:55:33 EDT 2018 | dnachristen
Hello! I have a calibration jig that handles both Philips / Assembleon and Samsung feeders. I have a power supply hooked up for the Samsung feeders, but would like to know if anyone has the pinout for those feeders so I can rig some kind of electroni
Electronics Forum | Tue May 21 12:58:15 EDT 2013 | highmillr
We have 2-Samsung 431's followed by a 421 on our line..We run different revision boards with similar parts. Is there a way I can run one revision feeder set up.Then switch over to the next job without having to switch feeders around for the new progr
Electronics Forum | Tue Apr 16 09:46:36 EDT 2019 | ttheis
We just bought a MVP Supra M machine and have put it under power but can not get the PC system to power on. I am following the power up procedure in the manual. Under power the conveyor controls work and the UPS backup turns on, but holding the key i
.gif)
