Electronics Forum | Thu Aug 26 03:22:06 EDT 1999 | Jacqueline Coia
Hi There, Could anyone please give me some pointers on screen printing non-conductive adhesives or where I could find the information avaliable. Aspects such as printing parameters, ideal stencil design and a general overview. Do already have a part
Electronics Forum | Mon Nov 13 08:24:03 EST 2000 | G. English
Richard, From your description of the IC, as Wolfgang indicates it sounds like a 20mil pitch device, the aperture design really depends upon your solder paste particle size, we use a type 3 solder paste with a mesh size of �325 / +500microns. This is
Electronics Forum | Fri Aug 13 18:38:47 EDT 2004 | russ
Your paste manufacturer will have the best guidelines for you. Different paste types and manufacturers sometimes/usually require a little bit different setup. I would also contact your printer manufacturer. As far as stencil concerns the larger/be
Electronics Forum | Tue Aug 01 12:38:13 EDT 2006 | razor9114
I would go with a 5 mil stencil as well, we experienced some similar issues with micro BGA's and the area ratio was suspect as well as the MESH size of the paste. We went to Type IV paste and verified our area ratio and everything ran beautifully. Pa
Electronics Forum | Mon Apr 12 15:52:12 EDT 2004 | wgaffubar
I am using Indium 92J type 4 solder paste due to a BGA site with .008" pads and stencil opening of .009" square and .005" stencil thickness. When I try the type 3 we get insuffecient print. The aspect ratio tells me that I should be using a type 4. T
Electronics Forum | Tue May 03 23:27:03 EDT 2016 | adamjs
I've successfully refrigerated a pasted board, and placed/reflowed it the next day with minimal issues. Me too. I'm looking for more than one day. > You might want to invest in a stencil cleaner Tried that. They do not work on the high-aspect ra
Electronics Forum | Mon Dec 17 12:11:29 EST 2007 | chef
Whoa dude - slow down- maybe great beer money but if you don't have good environmental and ESD controls in your shed, all your suds slush fund will evaporate in RMA's costs. A small pick and place (table top) would do. A manual screen printer would h
Electronics Forum | Tue Mar 21 02:15:26 EST 2006 | pavel_murtishev
Good morning Dave, Here are some of my assumptions. Please correct me if I am wrong. 1. Mask opening. Due to mask to PCB misregistration mask is not always centered relative to pad center how is should be. Sometimes edge of the mask matches with ed
Electronics Forum | Tue Dec 17 20:25:13 EST 2002 | iman
Check : 1) design aspect ratio / are ratio required to fabricate the stencil you r using. 2) check if the stencil maker is using your checked aspect ratio / area ratio? if not the same, what are they using? any QA report confirming actual dimension
Electronics Forum | Tue Dec 23 17:34:07 EST 2008 | davef
We hear you talking two main issues: 1 Solder paste release 2 Thoughts on using two passes of solder paste on the stencil 1 Solder paste release * Check your aperture & aspect ratios [Search the fine SMTnet Archives for more] * Do a better job with