Electronics Forum | Tue Apr 11 05:22:58 EDT 2017 | tsvetan
no problem at all, just the servo motors and ball bearings they have cost more than what I ask for the complete machine :)
Electronics Forum | Sun Mar 31 07:43:32 EDT 2013 | lkavan
Thank you very much, you are an angel, DOS software works with these drivers! But some servos still shaking and I cannot tune it by decreasing the gain or autotuning :-( Problem is with driver, when I change it servo works well. All drivers have the
Electronics Forum | Wed Mar 23 23:00:17 EST 2005 | pmd
Problem solved. Thru the help of MyData support we have determined that older MyDatas have a software issue with the servo drivers. A newer rev of driver will fix this problem.
Electronics Forum | Mon Nov 29 13:39:48 EST 2021 | oxygensmd
Is it a running machine or a first startup? For me, it seems to be some configuration error. For example problem with some card (iCos, MC, servo controller). At first check table and WPC connectors are fitted properly than check the status LEDs on y
Electronics Forum | Wed Dec 02 11:15:35 EST 2009 | tpappano
wycliffe (and I suppose anyone with a vision system): You may save yourself some considerable headache with your CSM84VZ if you check one simple thing before you get too far: Make sure the long skinny macro lens on the head camera is screwed in snu
Electronics Forum | Thu Jun 29 10:19:34 EDT 2023 | gfe
Hello, I have a problem with the mirae mx200l, the Y1 servo has error 38, does anyone know how to fix it?
Electronics Forum | Wed Dec 20 07:08:51 EST 2006 | cyber_wolf
We have had this happen. The Z-ball screws do go bad in IP3's. We replaced the ball screw and the problem went away. As mentioned improper belt tension will cause the servo to make loud noises. But if you say the movement is rough, then the ball scr
Electronics Forum | Thu Feb 13 09:52:03 EST 2014 | rgduval
Start by getting into the maintenance menu, and manually installing the Servo program for all MOTs. If they install fine, you can check the Z-motor while you're in the maintenance menus. Make sure that the z-locks are unlocked before checking the
Electronics Forum | Tue Jul 18 15:16:40 EDT 2017 | robertbronx
Showing on screen this message: MIPR2: Fatal Error. Reloading Motor Controller M First time I connect and only have this message on screen. The manual only says; 1) SOFTWARE PROBLEM IN THE MOT-M SERVO PROGRAM. 2) THE MOT-M OR MI board is broken. Plea
Electronics Forum | Wed Aug 24 11:32:08 EDT 2016 | mnorthey
Did you get your problem solved? I don't remember exactly what I did for that problem but it may have involved changing a servo or driver card. I do have a copy of the calibration/repair manual if you want it. I also have some Nozzles NC-1410 (1.0