Electronics Forum | Fri Jan 16 16:57:14 EST 2015 | dilogic
I doubt you will be able to get satisfactory results with 0201. 0402 is another story. When doing 0402 projects, we use only electric (MP) feeders and always at the same feeder slots (feeder teach done for each of them). MPF08 nozzle works fine. Also
Electronics Forum | Mon Jan 19 09:07:45 EST 2015 | cotinc01
We can offer several nozzles to assist with the placement of 0402/0201 components in the four-spindle head. We offer the 06MPF along with custom ceramic tipped nozzles. Most of our standard nozzles for this head type are less than $125.00 each. Chec
Electronics Forum | Wed May 03 13:35:00 EDT 2023 | ttheis
Thanks, Deni! We're replacing two 4-spindle GSM's with two GX-11S with Flex3 front and IL4 in the rear. These we plan to use a mix of our pneumatic & 24V feeders as well as high speed feeders as we acquire them. The sellers advised that the 24V kits
Electronics Forum | Wed Sep 21 12:30:03 EDT 2005 | Rob
Hi Greg, We've used lots of machines over the years & seen lots of different tape related issues - the main one being snap off of the cover tape, usually due to too much glue, over entusiastic heat seal, or a feeder requiring maintainance. Also the
Electronics Forum | Fri Feb 04 09:23:21 EST 2000 | Casimir Budzinski
If No-Clean flux does not need to be cleaned, then why do I get readings of up to 27(ug NaCl/sq in) on boards that are not washed, up to 23.4(ug NaCl/sq in) on boards washed with DI water only and from 1.2 to 10.1(ug NaCl/sq in) on boards washed with
Electronics Forum | Wed Aug 19 05:00:56 EDT 1998 | Tom Blum
Hi there, I'm actually facing a lot of trouble with PCB's presenting up to 3mm of bow /twist at reception i.e. before assembly. The PCB size is 220 by 230mm. The boards are to be assembeled SMD double sides with 05.mm pitch on both sides. In order to
Electronics Forum | Wed May 19 09:44:24 EDT 2004 | rlackey
Hello again Grant, In addition to our Fuji CPs we run Universal machines, and although they are pretty reliable, they are not in the same league. Regarding Fuji Placement speed we hit 30K plus on a couple of boards with no issues, but you do have t
Electronics Forum | Thu Sep 22 13:09:16 EDT 2005 | gregp
Thanks for the reply Rob, This we already do. The machine will pick from the most efficient available feeder (assuming multiples of the same part number)...so when you remove the primary it will seemlessly move to the next available. When you re-in
Electronics Forum | Sat Nov 03 10:57:27 EDT 2012 | davef
EricR: Regarding "*** By the way, since we have used the Tin-Silver-Copper lead free solder there has been a strange liquid type chemical leek from the oven exhausted pipes." ... I don't know anything about your process, but the first thing I'd inve
Electronics Forum | Fri Dec 13 15:40:53 EST 2002 | pjc
Too many British. Maybe some below can refer you to Dutch or Belgian companies. SMD-Taping Service Bartholomaeusweg 8 D-91522 Ansbach Germany Tel. / Fax: +49 981 17356 Tel.: +49 981 9724363 Fax: +49 981 9724364 www.smd-taping-service.com Reel Servi