Electronics Forum | Mon Nov 14 03:48:18 EST 2022 | frankchan
Maybe also check the air pressure, the lack of air pressure could also sometimes make the head lose grip on the nozzles
Electronics Forum | Fri Oct 03 07:49:19 EDT 2008 | grantp
Hi, I just saw the new NXT machines at globaltronics in Singapore, and mostly they are faster. However what was interesting is Fuji shows a prototype of the new XPF machine, but it was called XPF-W which handles really large PCB's and uses the sam
Electronics Forum | Wed Apr 26 19:07:44 EDT 2017 | jincuteguy
Hi guys, so we have 3 Philip Topaz smt machine at our work place. But 1 of them just got repaired and it needs to install the DOS windows or whatever Philip Topaz has originally. So is there anyways we can copy the DOS windows or DOS based operati
Electronics Forum | Thu Apr 27 05:48:32 EDT 2017 | pavel_murtishev
jin, The answer is no. DOS has to be installed from distributive normally supplied with machine. Hopefully, machine data has not been erased. If it has been erased, than machine will have to be recalibrated. Regards, Pavel
Electronics Forum | Fri Dec 15 08:32:13 EST 2017 | robertorocco
Hi Pavel it is possible to clone the hard disk topaz machine to replace it in the future crashed? how should I do to save the calibration data of the machine?
Electronics Forum | Fri Dec 22 05:24:23 EST 2017 | protokos
Hi ii is possible to clone a hard disk, but the calibration data must be backup first. if this not can, then the machine must be calibrated.
Electronics Forum | Tue Jan 09 08:53:48 EST 2018 | pavel_murtishev
Jin, Cloning is possible, but the machine will have to be recalibrated since calibration data from running machine will be copied to failed one. As to back ups. Are you able to get into engineering menu? Regards
Electronics Forum | Wed Nov 24 06:24:52 EST 2004 | Joe
Hi, I am an Engineering student doing some research on the component/nozzle interface on SMT Pick and Place machines. Could anyone tell me the force at which the nozzle hits the component as it is picked from the feeder or the placement force on a
Electronics Forum | Fri Feb 08 03:54:37 EST 2008 | muarty
I would think that you could quite easily use 0.6mm I/D nozzles even when using a hand syringe. As you say you are only using this for larger devices to prevent them from falling off. I am sure there are very reasonably priced small compressed air un
Electronics Forum | Mon Jan 19 09:07:45 EST 2015 | cotinc01
We can offer several nozzles to assist with the placement of 0402/0201 components in the four-spindle head. We offer the 06MPF along with custom ceramic tipped nozzles. Most of our standard nozzles for this head type are less than $125.00 each. Chec
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
Building A, Jiepeng Square, Fuyong
Shenzhen, China
Phone: 0755-33578694
