Electronics Forum | Mon Jul 28 19:03:53 EDT 2003 | Ryan Liao
Hi mantis, Thank you for your helps. I had checked the CP7 error code index application. It also gives me the same answer. It tell me " the part pickup status is bad" and I have to "Make sure that the nozzle is not bent and that the part is being pro
Electronics Forum | Fri Apr 27 13:35:46 EDT 2007 | sjpence
I do not know of any standard recommended values for impact pressure in cleaning equipment. They act more as a guide when examining the various choices manufacturers have made for the spray flow, nozzle pressure, nozzle spray angle and other factors.
Electronics Forum | Thu Nov 10 16:09:15 EST 2011 | davef
Third, if component placement is off, fix the machine (i.e. calibrate, check cleanliness of lenses and sensors, damaged nozzle) and not the CAD locations.
Electronics Forum | Thu Jul 28 08:02:09 EDT 2005 | stepheniii
Check the pick postion in the feeder. If the nozzle is picking at the edge of the component, it could flip it. BTW what kind of machine are you using? Stephen Olan
Electronics Forum | Thu Jul 20 03:00:53 EDT 2006 | reypal
If you are using SMT machine for component placement you may check your nozzle where in some cases solder paste stuck to it and during placement will easily get into gold pad area. otherwise you have use kapton tape in order not to expose those pads.
Electronics Forum | Wed Jun 03 19:19:37 EDT 2020 | kurtiss
Hello, I am having an issue with a Fuji CP4-3 where during the nozzle center the image displayed by both the wide and narrow view camera is a black square. We have checked the cable coming from the 4400 Card and all checks out. We have also pulled t
Electronics Forum | Thu Feb 05 08:39:35 EST 2004 | pjc
Dave is correct in that the Zevatech is actually a Juki. Made by the Japanese Juki and labeled by the Swiss Zevatech. The PM 575 is somewhat vintage. I believe it may be all mechanical component centering. It may be OK for the 20mil fine pitch but ma
Electronics Forum | Wed Jun 11 16:30:33 EDT 2003 | T.Vick
You have received some great feedback so far. I would like to summarize and add a few points regarding maintenance. You should start (as recommended already) by verifying your component library data. Using the default values from the master library i
Electronics Forum | Wed Aug 03 21:00:12 EDT 2005 | rcarlos28
Crishan, Do you check the Nozzle orientation? some machine use a Rectangular o circle nozzle body, and this reduce the vaccum. When this component is taked from the feeder and the camara measured recognized the pins? Do you change the type of rec
Electronics Forum | Wed Oct 22 06:06:54 EDT 2008 | stanyserrao
1CA64011 and 1CAFE011 UsedBy Display 1CA??011 Cause The Vision_type in part data is expressed using hexadecimal notation ("??"). If "??" equals 1E, 64, 78, 79, AC, or FE then boundary detection could not begin because the nozzle was bent.
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
Building A, Jiepeng Square, Fuyong
Shenzhen, China
Phone: 0755-33578694
.gif)
