Electronics Forum | Wed Aug 18 21:03:41 EDT 1999 | Dave F
| | | | | One of the DFM suggestions I've seen is to remove the solder mask web, i.e. the mask between pads on 20-mil QFP devices. The rational is that if the mask is thicker than the pad the mask can prevent the stencil from making intimate contact
Electronics Forum | Fri Aug 20 03:19:22 EDT 1999 | PeterB
| | | | | | One of the DFM suggestions I've seen is to remove the solder mask web, i.e. the mask between pads on 20-mil QFP devices. The rational is that if the mask is thicker than the pad the mask can prevent the stencil from making intimate conta
Electronics Forum | Thu Aug 10 03:30:42 EDT 2000 | JohnW
Ramon, Solder ball' are a bitch aint they?, identifying the right location to fix em is a bigger one. As you and the rest of teh guy's have said yes you'll need to look at your stenil..but maybe your stencil is good so you'll need to look else where
Electronics Forum | Thu Jul 27 12:09:41 EDT 2000 | JohnW
Jason, where on the board is your connector?, front / back / middle? and where it on the PCB that you don't have issues with? Thief pad's are basically dummy pad's taht you have after the last set of pin's on the component are are used to draw the
Electronics Forum | Thu Apr 06 02:23:50 EDT 2000 | Marcus
What about your printer and your stencil ? Do you have a problem with misalignment between pcb and stencil ? How often do you clean your stencil during production ? Maybe you have smearing under the stencil because there is a snapoff between stencil
Electronics Forum | Mon Aug 07 10:22:13 EDT 2000 | genglish
Ramon, I have had experience in the problems you are witnessing. The problem can relate to a number of factors. Obviously the printing process is the first place to start your investigations, try looking at the stencil apertures for bleed under the
Electronics Forum | Tue Nov 17 03:04:38 EST 1998 | Charles Stringer
For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the wave solder and
Electronics Forum | Tue May 02 13:07:55 EDT 2006 | Jbrower
Howdy all. The question that I have is on wave solder pallets. I'm getting quite a bit of flux trapped on the pcb where it contacts the wave solder pallet. I have an appropriate profile for my assemblies, The flux that i use is Kester 920-CXF No Cl
Electronics Forum | Fri Apr 13 22:38:19 EDT 2001 | edylc
Hi , Could you be seeing the nickel under the gold plating because you are removing some of the Gold with the Kapton Tape....?? You mean , the adhesive properties of the kapton tape will cause the gold plating on the gold finger to be somehow peel of
Electronics Forum | Wed Jun 23 13:34:29 EDT 2004 | df_indy
I am four weeks into my new job, there always seems to be some issues here with PCB every week. Today while I was checking some assemblies with micro-scope, I found a lot of tiny bubbles/blisters on the board. They are just little dots if you look
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
.gif)
