Electronics Forum | Tue Jan 25 14:12:55 EST 2011 | rodrigo
Hi All, I've been working with this machine for several weeks. I read the manual and I'm using the autoprogramming (ATT) with centroid data. I have a question regarding the teaching of the parts. Let's say I have 10 capacitors on the PCB that are th
Electronics Forum | Tue Jun 01 17:55:30 EDT 2004 | black5629
I am new with MPM printer,need help.I am trying to teach a new board, after selecting targets,when I exit teach vision ,it errors out "Board Model Not Found". Board orientation is correct. The books talks about Vision Y not squared to axis. Does anyo
Electronics Forum | Wed Jun 02 15:29:47 EDT 2004 | pr
Make sure the board is stopping at the center of the worknest or you will waste lots of time (you'll get software limit errors when you try to find fids.). If it's not in the center, you need to go in and reteach from scratch (doesn't take too long).
Electronics Forum | Thu Aug 21 19:18:47 EDT 2008 | duchoang
My steps are different in that case: 1- Check mounts. Try to adjust origin point until get the pretty good mount positions. 2- Teach fiducials ( Board fids, not panel fids) 3- Use fids, check mount again. 4- If OK, then teach Block Repeat. This alwas
Electronics Forum | Wed Oct 08 14:55:50 EDT 2008 | leemeyer
In the teach menu of Central controller and under Teach Board Fiducials there should be 6 options. Turn on Global Fiducial Correction by putting a Y in the box. Make sure all others including "Fiducial Data from Autoprogram" have an N in the box. Use
Electronics Forum | Sun May 12 15:08:28 EDT 2019 | dunks
Fixed! Someone else on here mentioned disabling the light control in sys.ini, and then the issue I was having was both teach boxes being plugged in( one may be faulty) and sys.ini said only 1 for teach position. I unplugged the rear teach box and now
Electronics Forum | Wed Dec 30 14:51:50 EST 2009 | gantry
Craig - It has been quite a while but from what I remember you teach the tray holder in teach table top. Then you have to put the part/tray on the the tray holder. Also, ensure the part is in your program. I don't remember where to do that but I
Electronics Forum | Wed Jun 02 11:19:18 EDT 2004 | black5629
I have a MPM3000, I have tried the multiple models still same problem. When you Teaching Board Stop Y, do you set the cross hair at the leading edge of the board?
Electronics Forum | Tue May 09 21:56:22 EDT 2006 | KEN
Yes. Teach 24mm feeder. 1. Set pickup to "Teaching" or "relative". 2. Adjust coordinate. 3. Celebrate with high fives and chest bumps like in the beer comercials.
Electronics Forum | Thu May 11 01:30:27 EDT 2006 | pavel_murtishev
Good morning, FYI, it's better to set "relative" instead of "teaching" for tape feeders. In this case optimizer will have an opportunity to change feeder position during program optimization. "Teaching" will fix feeder position and optimizer will ne