Electronics Forum | Sat Feb 19 05:34:45 EST 2000 | Dane Stokes
Also Jan, Don't you have to send your components through a filter program when transfering from a 4796 to a 4791 or vice versa. I know you have to do this when transfering a 4790 program to a 4791 because the speed data does not transfer correctly. I
Electronics Forum | Tue Aug 19 13:35:51 EDT 2008 | stefi
Hello, I need an advice regarding the next issue: in the case of Assembleon Topaz or Emerald SMT machines, is there necessary to teach first the block repeat coordinates and after that the PCB fiducial coordinates when you do not have these coordina
Electronics Forum | Wed Mar 31 06:08:45 EDT 2010 | miroyu
Hi everyone ! I started to program quad 4C for the first time and have some problems. First, board detection LED and proximity Led (on the front panel) are not lightning whatever I do! Second problem is I teach machine board size, nozzle locations
Electronics Forum | Thu Jun 22 03:27:08 EDT 2006 | dman97
Hi everyone, I was wondering if anyone knew of a backdoor setting in these machines that will allow you to change the machine configuration. At my company, we have one operator who decided it would be nice to lock everyone out of the user menus. He
Electronics Forum | Mon Feb 12 09:44:47 EST 2007 | SWAG
Enhanced board set-up, set conveyor width, load board, (your fiducials must be accurate!), use two fiducials to set reference point, click on placement(s), move crosshair to centerpoint, use two point teach to teach one point in the center or use cor
Electronics Forum | Sat Feb 27 20:06:13 EST 2010 | jmelson
Oh, the CSM only has one XY offset for each feeder rail. If you don't like it, you can teach any particular feeder location. The crazy thing is the teach camera is an inch in front of the heads (-25 mm Y) so you can't put the teach camera over the
Electronics Forum | Fri Feb 04 16:24:00 EST 2011 | snigro
Rodrigo I am the service manager of Mirtec. When your using ATT It tries to match the saved image to what is on the board. If the area isnt a good match, it will not program the part. At the bottom of the ATT window, select the tab labeled 'mmd file
Electronics Forum | Tue Apr 02 13:08:40 EDT 2013 | babe7362000
It has been years since I used autoprogram. But I believe your low reference number is your low slot number on the base and then the ref. is what slot you will teach your feeder ref. to the far left. And the High slot number is the higest slot numb
Electronics Forum | Mon Feb 12 08:37:04 EST 2018 | dontfeedphils
The piece that splits the vision probably has smudges or scratches on it. You're able to teach a set of pads. Before teaching the fid, hit the "Draw Correlation Box" button (I think that's what it's called, it's been a couple years). Then draw a b
Electronics Forum | Mon Dec 12 09:41:57 EST 2022 | poly
Thanks Peter, when I open feeder teach i'm presented with a bunch of actions. I can't find docs on what the different actions are. Do you know which one I should do? I have attempted to teach the corners but the value it gives put the PTF pick point