Electronics Forum | Wed Jan 12 09:03:09 EST 2005 | Rob
Hi Greg, I'm with you on that one - yes, as engineers we should be able to come back at sales people who claim their products walk on water, but you do seem to have had an excessively unfair kicking recently.
Electronics Forum | Tue Jan 31 13:22:15 EST 2006 | mgdrouin1
Does anyone have any information regarding damaged caused to components due to overheating primarily with a heatgun? I'm having a hard time getting engineering to comply. Thanks
Electronics Forum | Fri Apr 13 12:31:23 EDT 2012 | markhoch
*Like* (There should be a way to "Like" or "Dislike" replies so that other Engineers can agree or disagree with a response. Doens't this sound like a good idea?)
Electronics Forum | Wed Feb 01 08:12:04 EST 2006 | Chunks
OK, this is easy. You say HIGH fall out, so I can assume 25 or 50%? If so, run 10 without the heat gun and 10 with. This should show you if the heat gun process is the cause or not. If the relay is a surface mount, hand solder them on. If it's a
Electronics Forum | Fri May 07 07:02:52 EDT 2004 | rlackey
Hi Grant, We use the CP series from Fuji - so not quite the same, but the quality of engineering and company philosophy will almost certainly carry over into the XP range. Our machines are totally bombproof reliability wise, and the programming i
Electronics Forum | Fri Jun 04 16:00:52 EDT 2004 | bpan
I would never take it personal but my experience with the equipment has just been very GOOD. Just a note......I have known many former field service engineers who couldnt fix a thing....but thought they could.......and were too proud to ask for help
Electronics Forum | Fri Jun 04 19:59:18 EDT 2004 | Ken
Well, if they were "Field Service Engineers and couldn't fix a thing...how did they get hired"? And if this is the case then I would have to question the company's judgement and determination of my best interests for sending an unqualified, untraine
Electronics Forum | Fri Jun 04 20:08:13 EDT 2004 | Ken
Rick P. is the Assembleon local Field Service Engineer. He is very good. He is stationed in the Portland Metro area. Oregon and Washington have a very dense population of Philips (assembleon) machines. Extensive installation base. I recently in
Electronics Forum | Tue Jan 31 15:40:44 EST 2006 | mgdrouin1
Comp is relay. I've pulled the spec. Max 240. Using Leister h/g with manual temp settings from 1-6 (20 - 600C)set by the operator. Gun was set to setting 4. They are using the heat gun to reflow the solder after SMT but before wave. High fai
Electronics Forum | Mon Aug 04 09:30:16 EDT 2008 | grics
If you have concerns, you can look at the datasheet for each component or contact one of their application or materials engineers and find out what the components are rated for...process-wise. IE, how long can I be in the oven with this part, at what