Electronics Forum | Thu Mar 12 03:14:14 EDT 2009 | nibirta
Thank you for support. As i promised you, I am coming back with the results. The SM used was Probimer 77 with Kester 979 flux. The supplier says that there is an incompatibility and we have changed the flux with IF2009M. Same problem! They have chan
Electronics Forum | Mon May 07 16:00:38 EDT 2007 | patrickbruneel
Dave, There is not really a �smart� or scientific way to check this but I know of easy ways and very effective ways. Fex. an easy way to check is with a 3� spatula, you hold the spatula at the same angle as the board and drag trough the wave simula
Electronics Forum | Thu May 28 09:23:59 EDT 1998 | Chrys
| Hello, | | I need some users information about "hot air knife" after the wave | bath: | - Defects reduction ? | - In what kind of boards(TH/SMT SOICS ect.) it is applied ? | - Where can I purchase it as a retrofit (Soltec Delta 6622cc) ? |
Electronics Forum | Wed Mar 11 18:28:03 EDT 2015 | gregoryyork
Hi its undercured solder resist which leaves a clear waxy/oily residue and can be seen as brown tar/oil in the molten solder wave. This also causes MicroSolder Balling and some snail trails of solder pick up and worst case bridging and peeling resist
Electronics Forum | Thu May 07 13:22:37 EDT 1998 | Chrys
| I am running a board that is .062" thick and has components that over hang the edge of the board by .090". I have bottom side smt components (chip caps and resistors only) and use the turbulent wave to help solder the components. The problem I am
Electronics Forum | Tue Oct 11 14:02:59 EDT 2016 | mnorthey
We have a slider Bar on the back side of our Delta Wave. It is adjustable and slides up and down (adjusting bolt) on the back edge of the Lamda Wave to prevent this problem; keeping the trough behind the Lamda is essential as well. Along with attenti
Electronics Forum | Sat Oct 08 04:24:37 EDT 2016 | aaronpainter
We are having an issue with the solder bars hanging the solder feeder dripping down the back side of the pot, and leaking in to the area where the terminal block for the elements on the pot are. We have tried aluminum tape to close off the gap betwee
Electronics Forum | Thu May 15 13:42:12 EDT 2008 | sliebl
Typing "Optimizer Wave Solder" in Google brought back this: http://www.techinfocorp.com/wso/howandwhy.htm I have no relationship with this company.
Electronics Forum | Thu Feb 20 00:51:42 EST 2003 | Joe
We are running an RMA flux (Kester 1515). Changing the angle didn't help any so we're back at 6 degrees and placing an order for the lambda nozzle changeover. Are you currently running the debridging knife?
Electronics Forum | Thu Jun 17 13:51:32 EDT 1999 | Kelly Morris
| Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | for example: | | Solder Bridge | 1.verify amount of flux been aplied. | 2.verify turbulance on your solder wave. | 3.etc.
