Electronics Forum | Tue Oct 05 18:07:53 EDT 1999 | Bill Haynes
I hope that someone can help me with my problem! I am experiencing a lot of glued on parts falling off in the wave solder machine. A little information about my process: 1)We use Loctite 3609 glue that is used up long before its shelf life 2)Our pa
Electronics Forum | Thu Aug 30 20:35:51 EDT 2012 | davef
A common bottomside heater configuration is IR-Convection-Convection. One of the big advantages of the IR zone is its ability to allow the flux carrier to spread and dry slowly before the board reaches the convections zones, which can blow wet flux c
Electronics Forum | Mon Apr 01 19:57:07 EST 2002 | davef
Selective soldering machines are a good way to "finish automation", if the design of the PCB is conducive to the application with just a few components to solder. Your points are good. A decision matrix for selecting a machine might also include:
Electronics Forum | Fri Jan 13 12:12:48 EST 2006 | jimk
we have 4 bottom IR heaters and a 2 zone bottom Quartz heater (2 lamps/4 lamps) and 1 convection heater above zone 1 IR. we have very tight restrictions from customer and I could send profile view to your email if possible
Electronics Forum | Wed Jan 11 16:56:15 EST 2006 | russ
So are you saying that you cannot reach 110C at 1 location without raising another location to excessive preheat temp? If so, sometimes slowing down the conveyor and dropping the preheat temps will help you get equal temps. I do not know this machi
Electronics Forum | Thu Jul 06 12:52:35 EDT 2006 | samir
..and he can put the flux in and keep it a secret too from his customer.. RSS profile on wave?? I never heard of a soak zone for wave preheat...you may be burning off your activator..hence, the beads. For wave preheat, your main goal is to ramp up
Electronics Forum | Thu Nov 19 06:20:44 EST 1998 | Kelly
| For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the wave solder a
Electronics Forum | Thu Nov 19 10:12:38 EST 1998 | Brian Conner
| For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the wave solder a
Electronics Forum | Mon Dec 17 13:58:54 EST 2007 | ck_the_flip
I made my own wave measuring device using KIC2000 system. KIC2000 has automatic wave detection, so now I have a profiler for both reflow ovens and wave solder. The delmat carrier only cost $500. A guy, Samir, from this forum gave me the idea, actu
Electronics Forum | Mon Jul 10 07:46:51 EDT 2006 | ronalds
You are right, RSS profile is not the correct description. I am using a profile which heats up quickly to let the flux spread. Next linear up to activate the flux and prevent thermoshock. My experience is however, that small changes in this profile
.gif)
