Electronics Forum | Sun Jan 18 07:26:14 EST 1998 | cody chang
| I am looking to purchase a low cost manual P&P machine. I am interested in the equipment that has an X,Y table and an armrest for the operator. I don't want a computerized machine due to the (high) cost at this time. Does anyone have any experience
Electronics Forum | Wed May 01 22:20:02 EDT 2002 | saiwong
We can't affort the new QP132. It costs more than a million bucks each plus power feeders. We can only buy from the used markets. CP7's X-Y Table is moving too fast. They need special solder paste. Very expensive solder paste to hold the components.
Electronics Forum | Tue Aug 20 07:35:04 EDT 2002 | bmulcahy
Hi, I guess you a looking for a manual x-y table with a vacuum pick up such as SMT6000 from OK industries. I presume these are still being made-- We use one successfully at the end of a Mydata machine to place low volume components which we cannot j
Electronics Forum | Fri Apr 15 16:02:26 EDT 2005 | jdengler
ING, If my memory is correct: -This is from the large air cylinder below the X/Y table moving slow or not getting down all of the way. -The air cylinder has a sensor for when it's down all of the way. - This sensor could be bad but most of the t
Electronics Forum | Wed Jul 27 18:41:48 EDT 2005 | crishan
Aj, You are correct, we use pallets to hold the motherboard, an X-Y table then transports the pallet through preheat section to the solder bath. I will check out your recommendations on the solder alloy. Supplier is not willing to share PPM data o
Electronics Forum | Tue Mar 17 16:56:45 EDT 2009 | gregf912
Sorry Keith but is not possible to place 0201 parts on the CP43 machine. THe XY table is not tight enough on the resolution or the Z height. The parts camera will not be able to tell the part from the nozzle. THe CP6-4000 machine can not do 0201 part
Electronics Forum | Sat Nov 01 04:12:53 EDT 2008 | ashley
Hello mickd, The Fiducial Marks are normally etched along the vertical side of the PCB, therefore it will not be block by the XY table clamping rails. p.s. try to have a Shiny & Round Fiducial Mark as recommended by Fuji....so that you need not inp
Electronics Forum | Wed Oct 29 20:58:31 EDT 2008 | rmitchell
Hi, Our Fuji CP6 table is rising up abruptly when it unloads a pcb after populating it. It makes a clunking noise much louder than before. I don't see anything that has changed or gets in the way as far as the table rails lining up with the exit c
Electronics Forum | Tue Jul 12 03:57:55 EDT 2005 | woodglass
Hi, In the CP6 propers, there are values: PCB Check Position X, & PCB Check Position Y. These are the servo counts that the X/Y table moves to when checking if a PCB exists on the table. Your sensor does not detect a PCB, probably because when checki
Electronics Forum | Wed Apr 22 12:50:39 EDT 2020 | rodrigo
Hi all, One of our Fuji CP-642 machines has a weird problem. It does not happen every time but often enough that it is a problem. I power up and press start to zero it. The problem is the zero...ing does not finish. It moves the xy-table, D1/D2 table