Electronics Forum | Wed Jan 23 17:14:33 EST 2002 | Shawn
We have seen solder joints that have an orange peel or textured appearance to them after running over our wave solder machine. We thought it may be disturbed solder joints but it does not have the lines or appearance that a disturbed joint usually sh
Electronics Forum | Fri Feb 15 00:39:09 EST 2002 | Jones
I've noticed that after we have switched to Transition Automation blades on our MPM screen printers that the stencils seem to be wearing out faster and I see a wavy rippling effect across the length of the stencil thats impacted by the squeege blade.
Electronics Forum | Tue Feb 19 09:06:11 EST 2002 | davef
Just down the street from the Cheek to Cheek Dance Studio, eh? It does seem sad ... http://www.drummoynerugby.com.au/whatsnew.htm Because we came from the land down under. The woman blow and then blunder. Can�t you hear, can�t you hear the thunder
Electronics Forum | Sun Feb 24 02:21:39 EST 2002 | CJ
I work in a test-support role supporting a bluetooth production line. We use HP spectrum analysers in our final test solution and the solution to a lot of our fails is solved by calibrating these analysers. Normally we do both a Freq/Amplitude calibr
Electronics Forum | Sun Mar 03 07:22:03 EST 2002 | rkey
Hi, We've got one CSM60 and one CSM60V! After searching for a long time i've found the CSM Toolbox (/10) for UFO FIles !! Now i want to connect those machine's to a PC but i've tried everyhing but it doesn't work !! Does someone have experiance wi
Electronics Forum | Mon Mar 04 15:35:18 EST 2002 | caldon
I don't like hand lotions in the assembly area. If hand lotion is needed I would have the operators use latex gloves or finger cots. The lotion can be transfered to the bare board or assembly causing reliability issues. Lotion transfered to a bare PC
Electronics Forum | Thu Mar 07 19:19:41 EST 2002 | dason_c
Ron, you need to check all the thermal couples are in good shape and clean before ask the outside service to do the calibration. After the machine calibrated and I suggest that you run 2 profiles and all the heating zone set at the same temperture,
Electronics Forum | Wed Mar 06 21:21:48 EST 2002 | davef
DeltaScan, a Teradyne fixture-less tester coarsely comparable to HP TestJet, eh? Er, wazzat what Milo [contact programmer at CTU on 24] used to hack into the key card that Richard Walsh [CTU honcho shot dead at Dupont plaza] gave to Jack [this is go
Electronics Forum | Wed Mar 20 11:55:19 EST 2002 | slthomas
Interesting. Ours failed miserably. Of course we toss everything on the stencil at the end of a shift (they are instructed to let it run down to minimal volume on the stencil as they approach quitting time) so it's not an issue. We are more concer
Electronics Forum | Thu Mar 21 13:59:24 EST 2002 | vargas_s
We are actively looking to buy a Fuji CP6 series placement machine in the used market. We constructed a questionnaire for perspective sellers trying to get as much information out of them as we can regarding possible machines (serial numbers, dates,