Electronics Forum | Fri Sep 07 17:03:10 EDT 2012 | burb1999
I would guess the FFX cable as metioned with the sensors inside the midas, that could of been damaged by a part or? Not a big deal to replace just remember how many turns the milar harness goes around. Also just loosen the rear screw there is a slo
Electronics Forum | Thu Sep 19 10:27:10 EDT 2013 | rgduval
I believe there is a force calibration menu option in the maintenance menu. From the main screen, choose exit to maintenance to get into the maintenance menus. If you're still having force issues afterwards, you'll want to start hunting for broke
Electronics Forum | Fri Sep 14 10:30:45 EDT 2012 | dekhead
I believe there was a software issue as well; Initially installed software (4.03) replacing existing 2.12. After that it got past the "Stack Overflow" and displayed the expected error for incorrect addressing on PCAD12... BTW solution to "vision boa
Electronics Forum | Fri Feb 15 21:52:06 EST 2013 | nikyta
Most likely it is a faulty cable in the e-chain . You can test it in diagnostic: lower the back squeege and manually move back and forth for its entire travel the print carriage while monitoring the sensor output of the squeege. You will see at some
Electronics Forum | Tue Mar 19 17:17:25 EDT 2013 | technitelec
Hello to everybody i am looking for someone that can tell me how to bypass one faulty module on Fuji NXT machine, i have one module that is always in Emergency stop i think that the problem is coming from a bad cable and i need to keep ru
Electronics Forum | Thu Aug 29 14:41:10 EDT 2013 | kdc45
We found we had a bad communication cable which caused all of the files to be corrupted. We then held the RESET down while powering up and it successfully dumped. We were then able to send status, proper and programs to the machines. Hope this helps
Electronics Forum | Fri Sep 06 12:34:00 EDT 2013 | bobpan
Your firmware is so old that the problem is not in the mod codes anyways. You have a problem with the cyberoptics head. If its not working at all, i would remove the lens assy on the front side where the cable plugs in and blow out the unit. Maybe if
Electronics Forum | Wed Jan 29 18:41:22 EST 2014 | alphatronique
Hi did you look for mechanical issue like friction somewhere ? when init i use very low force buy much more while running that may explain wly machine work in production fur fail only on init i face that whit flex cable that make just little fr
Electronics Forum | Wed Sep 17 10:28:05 EDT 2014 | travishemen
We had a Dek 265 LT that had a similar issue. We suspected it was a bad cable going to the camera as the issue always seemed to show up in the same X Y location. Have you tried swapping fiducial 1 and 2 to see if it is always the first fiducial or
Electronics Forum | Tue Sep 01 10:55:41 EDT 2015 | emeto
Hi, 1. Take a multi meter and measure the voltage - I assume it is a DC motor(probably 24V). If you don't, check power supply,cable, relays and Driver for the motor. If you do have voltage, check sensors(sometimes sensor activated may stop your con
