Electronics Forum | Mon Jun 13 09:17:05 EDT 2005 | russ
Some machines may require that the two locals be used to calculate a center point where some (probably most) just use them as a second positional identifier. The fiducials are programmed as just XY and just prior to placement the machine will read th
Electronics Forum | Tue Sep 20 16:19:44 EDT 2005 | gregp
Hello all, I am looking for a general opinion on splicing tapes. It has always been my opinion that splicing was an after thought for the machines that did not allow feeder removal and replacement during machine operation. If the machine has the ab
Electronics Forum | Thu Dec 29 22:19:36 EST 2005 | Joseph
We have tested SN100C for LF wave soldering process since August'05 and currently start production for a month ago. Initially we use SAC305, but due to the shrinkage cavities (micro-crack) we changeover to SN100C. In summary, SN100C did perform well
Electronics Forum | Tue Feb 14 09:35:25 EST 2006 | Baer
Let me give some information on the use of MS2. The average wave solder machine will use one liter per five day week per 8 hour shift. The usage can vary + or - 20%. Instead of removing 6 to 10 Lbs of dross every 3 hours you will have to remove 100 M
Electronics Forum | Tue Mar 07 21:35:16 EST 2006 | Cal Kolokoy
Samir, From experience, the only board test situation where tented via's have difficulty with contact is with a Flying Probe type tester. Otherwise, for traditional ICT, the force of the pogo pins, correct probe type, and fixture design should do th
Electronics Forum | Mon Mar 13 18:06:35 EST 2006 | slthomas
So, if 45� is theoretically optimal for aperture fill, but 60� is better for defining fine pitch bricks, is 52.5� the best compromise for an all around design, or does it not work that way? I see blades with either one angle or the other but with th
Electronics Forum | Thu Jun 01 04:51:21 EDT 2006 | EC
Hi TS, Most of the machines will face this problem after been using few years.....I handling SMT equipments ( Fuji machine ) and process.....sorry if I have offened you...... Hi Jack, Firstly, you must able to tell which component having a high thr
Electronics Forum | Thu Jul 13 13:51:13 EDT 2006 | George
I got some info about it last year. I could not justify ROI since this machine was way too expensive (same thing with Vitronics Selective machines). You need to see if this machine will increase your throughput or not depending on your products. Al
Electronics Forum | Tue Jul 18 23:11:03 EDT 2006 | Utog Oten
Hello folks I am seeking advice and guidance on a screen print machine who the best manufacturers are of this equipment and so fourth. I got budgetary approval from the management to purchase a medium volume electronics line. Our engineer sup. seems
Electronics Forum | Thu Aug 10 10:00:40 EDT 2006 | slthomas
Temp. and humidity levels are dependant upon your chemical (paste and adhesive) specifications. Ballpark I'd say 70�F and 40%-45% RH are good targets, as our paste spec. says optimal ranges are 70-77� and 30-70 RH. As far as air quality, if you bui