Electronics Forum | Fri Mar 08 05:44:40 EST 2019 | bukas
are you sure #1 and #6 are interchangeable? if I remember correctly there is a catch with those motors, like there are 2 groups, group 1 being #1 #3 #5 and group 2 being #2 #4 and #6. maybe try getting it back and swapping cables at drivers for head
Electronics Forum | Fri Mar 22 13:32:15 EDT 2019 | kahrpr
all the motors on the head are the same just the connecting cable are different length. the motors have a home position for the zero pulse that home position has to match when the flag passes through the homing sensor all servos have a home position
Electronics Forum | Mon May 06 10:50:11 EDT 2019 | youngbuck
Hi Kristof, I checked the tacho everything is ok with that, its reading a constant 0 -0 and belt tension looks good. Not sure what else to try. The smema problem is that it will not accept a board from the previous S20. Ive changed smema cables, s
Electronics Forum | Fri May 24 11:34:08 EDT 2019 | jstebbs89
Running a Mydata 15E and in the middle of a board the machine will freeze. Restart the machine and try to initiate the hardware, get an error message of F-MOT-MSETDYN X/163: Illegal value of DSP command arguement I've check all the connections on t
Electronics Forum | Wed Jun 19 09:08:30 EDT 2019 | BigFuji642
I'm trying to get a Fuji CP 642 to communicate with Flexa and I am having some difficulties. The machine has a RS232 25pin Data Port on the side of the machine. There is also a RS232 25pin Device Port located under the Data Port. Do both the Data
Electronics Forum | Tue Jul 02 10:34:48 EDT 2019 | dman97
You should be using the diagram on page 4. 9pin to 25 pin. Flexa settings should be set to NT C/C. You have to make sure that the COM settings in windows are set correctly for the USB adapter you are using. Whatever COM port windows assigns to the US
Electronics Forum | Tue Jul 02 11:04:20 EDT 2019 | dman97
The pin outs are not mirrored. The proper data files usually come on a disk and are usually inside one of the cabinets on the machine. Chances are that the proper data disk is MCS formatted. In order to extract the proper data from the disk you woul
Electronics Forum | Wed Jul 24 10:57:32 EDT 2019 | aharper
We recently acquired an EKRA E5 (vintage 1999), and I am receiving a "Machine Offline" error. I discovered a cable labeled "X20b" that is disconnected, but I cannot find the port it should be connected to. I do have the manual but have not found any
Electronics Forum | Wed Jan 06 12:19:30 EST 2021 | oxygensmd
If you get Machine Offline error, that means the backPC non-working or there are some connection issue between front and back PCs. FrontPC is normally a standard PC, backPC normally is a 4U-size industrial PC. I had the same issue in the past, multi
Electronics Forum | Thu Aug 22 11:30:47 EDT 2019 | rgduval
It's a motor controller card error. I'm not completely sure, but, it seems like something in the x. Swap MOT1 with MOT2 or 3, and see if the error moves. If it does, you have a bad MOT card. If it doesn't, you have something going on with a motor
.gif)
