Electronics Forum | Thu Jun 21 00:35:21 EDT 2018 | reckless
I just bought this GSM for $1500: https://www.youtube.com/watch?v=mYExLDwlJLc&feature=youtu.be It has 1 flexjet head and OS2. I need to buy 15 8x2mm feeders and some 12mm. Do I buy pneumatic or electric? My service tech says electric is a waste o
Electronics Forum | Thu Mar 15 00:53:06 EDT 2018 | dpalombo
We are looking for a domestic contract assembler that has experience placing Zierick pins onto IMS boards. Specifically we need to place the A1, A2, A3 and A4 pins of any length. Information on the pins can be found here: http://www.zierick.com/pa
Electronics Forum | Sun Mar 18 20:15:06 EDT 2018 | stephenj37824
Thanks so much for the reply. I had looked at Juki but must have missed that model. I see what you are saying about the dispensing. I was looking at the Mycronic solder jet system the My700 I believe. I have watched a few videos detailing the pros an
Electronics Forum | Tue Mar 20 04:40:15 EDT 2018 | rob
I've seen them down at 2 metres in the past, but usually only 4 zone. from memory Electrovert used to do a small 5 zone with pin chain - Infraflow 500 or something. To be fair, even small one line CEMs usually have a decent oven as you need to be a
Electronics Forum | Wed Mar 28 11:59:32 EDT 2018 | robl
15000 hours is nothing we have Jukis and Assembleon/Yamaha's on 50K. What maters is how they are looked after. Ours are looked after very well. Also, what does the programming software cost? Regarding the Quad 4C, yes the support would be great,w
Electronics Forum | Thu Mar 29 08:24:57 EDT 2018 | alexeis
Hi, We have developed solution, called Dashboard, that shows a performance data of SMT machines at online. Also, it has build-in reports including information that you need. If you want more information, you can send me an email: alexeis@proventust
Electronics Forum | Fri Aug 17 01:49:51 EDT 2018 | buckcho
Traceability can be made for many things. It is up to the factory and what it wants to implement. You can have traceability on the stencil for a several reasons: 1. Want to check stencil cycles 2. Want to verify if stencil is the correct one loaded 3
Electronics Forum | Wed Aug 22 10:28:19 EDT 2018 | buckcho
I have the same machines, haven't figured it out yet. Only idea i got is to scan every batch and get a rough number of the prints. For example if you have an order of 500 panels, usually it would take 500prints to produce them (maybe 4-5 differences
Electronics Forum | Wed Jul 18 03:57:15 EDT 2018 | cannizzaro
We use eagle for PCB prototype design but it does not have in Gerber CAM scripts by default, when we export the Gerber, layer seems to be wrong place. I want ask you how I can do proper Gerber output for bottom silkscreen as long other layers (mask,
Electronics Forum | Wed Aug 29 09:32:27 EDT 2018 | m_imtiaz
Dear All We are using structural similar type of connector in A & B product with same set parameter in selective soldering machine but result in B product is not good. Observation – Plating on A product Connector terminal done on all 4 side But In
