Electronics Forum | Fri Dec 27 17:13:53 EST 2019 | rhormigox
Thank you for the answers. The paste is as spec No-Clean https://www.chipquik.com/datasheets/TS391SNL50.pdf I'am writing them too. For the excessive cooking not sure, the oven sensor (that I think is about right) looks I am close to the profile, bu
Electronics Forum | Mon Dec 30 12:48:18 EST 2019 | rgduval
Keep in mind that the oven temperature does not, necessarily, equate to the board temperature. The thermal characteristics of the parts and copper will cause the board temperature to be different, sometimes significantly, than the oven temperature.
Electronics Forum | Tue Dec 31 02:04:19 EST 2019 | sssamw
From the picture, I cannot see clearly solder ball violate electrical clearance or cause a short, maybe it is. What I can see is the solder paste has some misalignment although it doesn't printed in solder mask area, but actual position will reduce
Electronics Forum | Thu Jan 02 22:09:15 EST 2020 | Zack
Hello, Can you give more detail on LGA parts in question? is 50 mm x 50 mm is overall size of the parts? What about pad pitch and how big is the pads individually? I assume that 50x50 mm is overall size. How about the stencil opening for the LGA pad
Electronics Forum | Wed Jan 29 18:31:06 EST 2020 | slthomas
The 4 places I've worked in SMT all had their own solutions for their own reason. I quit worrying about what worked best if what I had worked OK. I've only seen (or recognized, at least) tension issues on foils that had been saved well beyond a rea
Electronics Forum | Thu Jan 30 07:09:34 EST 2020 | jineshjpr
Hi All, I'm using 8 zone reflow for ROHS 0.2mm Thick PCB soldering, but Micro BGA shows voids more than 25%. Is there anybody can suggest for better solder profile. paste- aim m8, SAC 305, T4, Soaking (150-200) - tried 90s, 60s, 45s; TAL (>217)-
Electronics Forum | Fri Feb 07 20:41:52 EST 2020 | orbitcoms
I am finding if I have to stop the pick and place machine during production very often (mostly due to feeders not pulling the tape cover back), I get paste drying in the apertures of the stencil. To avoid this I am thinking of pasting all the boards
Electronics Forum | Tue Feb 18 20:04:38 EST 2020 | SMTA-Alex
Sebas, some things in your profile don't make sense. 3 of your thermocouples, #1 # 4 and #6 are consistent. The others show completely different data. The consistent thermocouples, also, show peak temp at 241 - 243 degrees. That is extermely high for
Electronics Forum | Thu Mar 05 07:40:55 EST 2020 | tomdegas
I swapped the mi boards with ones from a working My12 machine and the same results. To recap my problem: On "Hardware Initialization" the center jaws open and close, the Hydra Theta belt moves back and forth, the Hydra head moves all the way down an
Electronics Forum | Tue Feb 25 15:28:07 EST 2020 | SMTA-Alex
TPSys is the machine operating system, proprietary from Mydata (Mycronic, now). It's based on Linux. You have to purchase the upgrades from Mycronic. Depending on which version you're upgrading from, the cost might vary. If the machine you're buying
