Electronics Forum | Tue Mar 03 03:38:46 EST 2020 | toki
Hello everyone, I would like to know what is the current trend in SMT line setup in terms of assembling both side pcbs at one go. Is it dual lane or single lane double line set up? Thanks
Electronics Forum | Tue Jun 09 16:29:03 EDT 2020 | dilogic
Since rear feeder bank can be in three different positions, machine must know which one it is. Check in Machine Setup, Parameters - Feeders (see attached image). It that's set wrong, machine will try to reach position out of range and will hit end sw
Electronics Forum | Thu Jul 23 06:15:33 EDT 2020 | bukas
There is a oven setup wizard on my 1809. your oven probably has one too. there you should be able to adjust blower speed for each zone.
Electronics Forum | Tue Sep 29 18:54:17 EDT 2020 | smitty
Has anyone experienced issues with the Red-E-Set support system damaging components on double sided boards? How's the setup, its advertised as quick? Any issue with misprints using this support system?
Electronics Forum | Tue Nov 03 14:29:40 EST 2020 | emeto
You should narrow it down more. Your list is easily achievable by most of the machines on the market. There are things like throughput, factory layout, traceability, number of operators to run the line, setup requirements, flexibility, product range
Electronics Forum | Mon Nov 09 15:44:39 EST 2020 | mikewschomisch
DEK 265LT displays CMOC is BAD: Restoring from EEPROM.... EEPROM is BAD: No Restore was made. You MUST run SETUP followed by LOCKMOS... FAILED Any help appreciated.
Electronics Forum | Tue Nov 10 19:20:34 EST 2020 | dekhead
Can you manually enter CMOS information in Setup and boot from there?
Electronics Forum | Tue Nov 10 19:31:09 EST 2020 | mikewschomisch
I have been able to manually enter CMOS info in SETUP thanks to suggestions from this forum and get past the CMOS and EEPROM failures. Now stuck "diskette error". Any key will produce the same message. Thanks.
Electronics Forum | Tue Nov 10 21:00:41 EST 2020 | mikewschomisch
I removed the ribbon cable from the FDD and edited the setting in SETUP to "NOT Installed";. Came back with 'Diskette drive failure on drive A'. on reboot. Still shows "Diskette error" on last line. Possible HDD issue? Thanks.
Electronics Forum | Thu Mar 11 13:09:52 EST 2021 | processman
Hello, Hoping for some help, we have Hesse BJ820 wirebond machine and after changing to new spool of wire the wire snaps after first bond. Anyone have any idea ? Wire is in date and no change in machine setup, just change spool of wire.