Electronics Forum | Mon Aug 13 13:00:49 EDT 2012 | graememurphy
The problem was that the wiring between the overtemperature capillary thermostats had burnt away. There are eight of these, four on the bottom half and four on the top half of the heat chamber. A rubber blanking grommet covers the adjustment shaft of
Electronics Forum | Fri May 02 11:09:13 EDT 2014 | pawloa
Hello. We have a Minipak 300 wave solder machine from Electrovert and are looking in particular for a tachometer that attaches on the finger conveyor motor to measure the speed in pulses. We are also looking for the thermocouple that is used to moni
Electronics Forum | Wed Aug 13 19:57:05 EDT 2014 | suroy
After wash cycle, some of the inductors are open (broken wire). Resistance across the two ends should be below 4 ohms (normal) however on broken wire shows above 200 ohms. I am wondering if anyone else has seen this problem. We are using High-Reliabi
Electronics Forum | Mon Oct 03 21:02:23 EDT 2016 | rwd
I am doing some rework to my CCA. I then need to conformal coat the board. I'm using Humiseal 1A33 GEL and my jumper wires are teflon coated. I understand the chemical interaction between the 2 products. My question is "Is this an acceptable prac
Electronics Forum | Wed Jul 26 17:32:39 EDT 2017 | circustactics
Anyone familiar with the K&S 4524A Wire Bonder? I'm trying to troubleshoot an issue: It fails to save or load programs. The tool will startup with the default parameters in program 1. The parameters can be changed but attempting to save to another pr
Electronics Forum | Tue Oct 10 09:16:30 EDT 2017 | davidbleeke
I have an Ersa Hotflow 5 reflow oven. I think someone rewired the cooling fan. It is constantly running. I am not able to open the hood with the buttons either. Does anyone have the manual? I would like to get copies of it or the wiring diagrams. Any
Electronics Forum | Tue Mar 13 20:47:39 EDT 2018 | davef
I think of palladium coated copper with gold flash (CuPdAu) as bond wire used in chip attach. Look here: https://www.heraeus.com/media/media/het/doc_het/products_and_solutions_het_documents/bonding_wires_documents/fact_sheets/Factsheet_PdFlash.pdf
Electronics Forum | Wed Nov 11 11:50:19 EST 2020 | paulanderson
An update. I managed to resolve the issue by wiring my own :) got a friend with a UK spec MY12 to take pics of the internal connections of theirs and then hard wired ours to match - worked perfectly. message me if you have a similar problem and I ca
Electronics Forum | Wed Mar 03 11:18:59 EST 2021 | guitarguy68
We've got a couple of old jumper wire formers here at our workplace that I'm looking for a part for. They're originally from the Eraser Co. They no longer have any parts for this. I'm going to attach 2 photos that show the former and the part we n
Electronics Forum | Fri Apr 08 12:32:12 EDT 2022 | jblundon
I have a Komax Iota 330. It's a great machine. Accurate, fast, easy to service. We cut plastic shrink tubing as small as 1/8" diameter, plastic convoluted wire loom, metal mesh wire loom, plastic air line, and more. We easily process more than one mi
