Electronics Forum | Mon May 09 19:24:53 EDT 2022 | rgduval
It's been a minute...but, does the My9 still have MOT boards in the computer cage? If so, swap the MOTz with the MOTx or MOTy, and see if the problem moves. If so, replace the motor controller board. If not, +1 on the encoder or Z-motor. Check fo
Electronics Forum | Mon May 09 19:27:19 EDT 2022 | mikevb
Thanks for the response. Yes, the z motor initializes in the service program just fine. It moves and reads a position. Also in the service program, I try to test the z force sensor and it gives me the same error - no z indicator at all. All cables ar
Electronics Forum | Wed May 25 12:09:52 EDT 2022 | stevemiles
Hi, I've had this problem with two DEK Horizon 03i printers. The first time it was the camera (firewire) causing the PC to freeze. The second time it was the firewire card in the PC that was the problem. Try moving the camera firewire cable to a d
Electronics Forum | Fri Aug 19 08:32:54 EDT 2022 | angela t
The GKG G5 press has occasional drive alarms, sometimes it turns off and restarts, sometimes it needs to be unplugged from the board cable at the back and the alarm returns after a period of production. What is the problem? Could any of you give me a
Electronics Forum | Sat Dec 31 00:52:33 EST 2022 | sarason
Next step trace the RS232 cable. Check all output voltages on your power supplys, b oth loaded an d unloaded. Note any differences. Check he impedancesa of your loads ie is your 24 volt load only measuring a few ohms. You may have a short? sarason
Electronics Forum | Thu Mar 23 13:36:30 EDT 2023 | tomdegas
Running a Mydata MY 9 and trying to Restart the machine and try to initiate the hardware, get an error message of F-MOT-MSETDYN X/163: Illegal value of DSP command argument. It seems to be related to the x drive. I've check all the connections on
Electronics Forum | Sat Mar 25 12:51:14 EDT 2023 | rgduval
Swap mot cards and see if the error moves. Of it does, your issue is the mot card, if it doesn't, your issue is one of the above. Try calibrating in the service menu. Check your friction readings. Check the x-encoder (attached to the motor).
Electronics Forum | Sun Aug 13 22:31:58 EDT 2023 | cspasol
Hi! I have encountered this problem so many times. Here are the possible cause of your machine problem. 1. PCI board or PCI to motherboard cable. 2. VME memmory card. 3. VME board itself. 4. Power supply for VME board. Hope could help.
Electronics Forum | Wed Apr 17 02:13:22 EDT 2024 | acouto
Good morning, After the visit of an external technician due to the change of cables, when resetting the camera mark again when doing the inspection fails to check the calibration points of the conveyor. Is it possible that the technician has decalibr
Electronics Forum | Sun Dec 04 02:20:20 EST 2011 | ngineer
I just got my hands on a Quad IVc, and am trying to find information on a Z-axis Error # 5 @ startup. I haven't really done anything since recieving the machine, I powered on, the Transport moves back and forth, the pc boots and I press enter to log
.gif)
