Electronics Forum | Mon Nov 10 04:05:56 EST 2014 | moshe_shmuel
We are working with SMT lines consisting of machines opalxii after 5/6 years of operation have appeared problems in operation of the engines on the x and y axes. I disassembled the engines from the machine and I removed the cap that covers the encod
Electronics Forum | Tue Nov 25 08:36:32 EST 2014 | bobpan
Tep stands for the transport card. The board is located in the front bottom left of the machine and should be by itself and have green and red leds lit on the top of it. I would try to reseat the card and then try to reboot the machine. If the proble
Electronics Forum | Fri Dec 05 05:02:27 EST 2014 | sarason
When I was a younger man with a younger mans eyes it was easy to outplace a hand placement machine. Good hand eye co-ordination is all that is required now I would find it easier to use the machine , but my fine motor skills are still just as good. A
Electronics Forum | Tue Feb 24 03:36:37 EST 2015 | jlawson
Also should look at Viscom 3088Flex Ultra if after AOI with 3D capability. The camera optics module has many innovative features, super fast data capture - much faster then Mirtek and KohYoung. Both these companies have taken 3DSPI and turned into AO
Electronics Forum | Thu Feb 26 12:58:21 EST 2015 | daniel_esposito
Hi everyone! I have P&P Quad IVc. The Hand Held Terminal (HHT)says "V idle" intead of "V ENTER CMD", and when it is running, the HHT shows commands lines each one at the same time it is running. One of our technician entered mistakenly, at the HHT,
Electronics Forum | Wed Mar 04 10:59:24 EST 2015 | jpierre
Hi first DS65 version is a specific dilution for dispensing machine, in this case the typical process is following: application of the conformal coating extraction of solvent (low extraction power is better)2minutes and drying the drying can be done
Electronics Forum | Mon Mar 16 06:12:32 EDT 2015 | bobpan
The first thing to do is to change the z-rod. Sometimes a very old z-rod spring will weaken causing it to reject many parts. If it only rejects parts after a nozzle change....you may need to put some super lube grease on the O-rings on the bottom of
Electronics Forum | Fri Apr 17 12:09:21 EDT 2015 | ilavu
Hello All, I am in need for "Platform Set-up Validation" (PSV) for my Universal GSM2 with UPS version 4.5. My installation disk for PSV is bad and can not reinstall after hard drive crash.My machine is not register with Universal because some serial
Electronics Forum | Sat Jun 20 14:26:41 EDT 2015 | lord_anar
Hi all. We have MYDATA MY5OO Jet Printer. We had already used it before. But now when we start to production again after a long time I have problems with CAD Conversion. I forget all of the information about how to start working on jet printer and MY
Electronics Forum | Tue Jul 14 01:48:43 EDT 2015 | buckcho
Hello. I used Heller before - very stable oven, I had zero problems. Maintenance is also very easy. I also think they are not so expensive. You have to look at the power consumption and N2 if you are going to use it. Some ovens can trick you with low