Electronics Forum | Tue Feb 13 15:27:09 EST 2007 | davef
Roland On the main Forum page, the ads in the right margin are back to their old piggyselves again. They've bloated themselves upto 2.5 inches wide from their former svelt 1.5 inches wide. Portion control and exercise, portion control and exercis
Electronics Forum | Tue Apr 17 17:30:09 EDT 2007 | jaimebc
Our experience with leaded paste and SAC305, for 0402's, has been positive with the following stencil designs: 1.- 5 mil thickness. 2.- Home plate design. Hope it helps.
Electronics Forum | Fri Nov 21 12:26:47 EST 2008 | karkanov
Hi everyone!! Is anybody have a chart or rule or standard for misprint. What I mean is if there is a way of saying if my print for some reason a switch 1%, 5%, 10%, etc, off the pad that is not acceptable. Thank you Yannick
Electronics Forum | Fri Jun 26 05:18:28 EDT 2009 | rway
Contact Elect-Test Fixtures, 484-921-5350. They build our test fixtures and we get most of our fixture supplies from them. They have the standard 1" and 1.5" hold-down pins. They may have other lengths as well. Tell them Reese sent you.
Electronics Forum | Tue Mar 23 12:27:21 EDT 2010 | deltaservices
I have 1.5 available, send me your email adress and i can forward it to you
Electronics Forum | Fri Feb 19 06:45:58 EST 2010 | kenadams
Why was it down before? It's possible you have bad cabling. Voltage will read okay but it/they will require very little resistance to work properly (like less than 1.5 ohms).
Electronics Forum | Thu Sep 01 11:53:04 EDT 2011 | emeto
Hi Reese, unfortunetely our AOI isnot in line and yes we check first article for each board on the AOI.One of each five boards 1/5 we give to inspector to check and we X-ray if needed.
Electronics Forum | Wed Aug 24 03:12:01 EDT 2011 | richieoreilly
Hi, The solder we use is Sn5Pb93.5Ag1.5. with a melting point of about 30 degrees.
Electronics Forum | Thu Aug 09 01:05:03 EDT 2012 | sajith09
I would like to understand What will be the allowable warpage for 152mm length PCB. We are observing about 1.5mm warpage. Is that acceptable? Could you please share method to calculate the warpage
Electronics Forum | Fri Feb 15 08:31:03 EST 2013 | cyber_wolf
I believe you need 1.5.13 or higher if I'm not mistaken to run the mags with the button upgrade. There is no way around it that I am aware of.