Electronics Forum | Tue Jul 26 19:07:30 EDT 2022 | nextgen
Thank you for your input Austin. That is exactly what happened. When I replaced the mixed bed, the smell stop.
Electronics Forum | Tue Jun 01 15:09:58 EDT 1999 | Tony
| Dear All, | | We are a medium sized sub contract manufacturing house, engaged in high mix, medium volume production. We are using no clean as well as Aqueous cleaning process. we are planning to buy a new wave soldering machine out of the follow
Electronics Forum | Wed Jun 02 04:04:58 EDT 1999 | Vinesh Gandhi
| | Dear All, | | | | We are a medium sized sub contract manufacturing house, engaged in high mix, medium volume production. We are using no clean as well as Aqueous cleaning process. we are planning to buy a new wave soldering machine out of the
Electronics Forum | Wed Jun 02 19:31:01 EDT 1999 | Tony
| | | Dear All, | | | | | | We are a medium sized sub contract manufacturing house, engaged in high mix, medium volume production. We are using no clean as well as Aqueous cleaning process. we are planning to buy a new wave soldering machine out o
Electronics Forum | Tue Feb 24 16:57:03 EST 1998 | henry
EQUIPMENT FOR SALE QUAD 100 V3/V6 Low hours, Excellent condition, All latest factory revisions Firmware 3.65 Central controller software 5.6D with computer system Autoprogram software 5.31 1- 28" Latching feeder base 5- 4" Latching feeder b
Electronics Forum | Wed Aug 07 17:55:33 EDT 2019 | slthomas
You should be well within area and aspect ration guidelines with that. Are you printing and placing close to center on the pads? Sometimes operators will "bump" the parts to center them on the pads if they're not placed correctly, and if they've bee
Electronics Forum | Thu Aug 08 13:05:45 EDT 2019 | horchak
What is your pad width? What is lead width? Is the part gang masked, or has masking between the pads? Pads plated or HASL, if HASL how thick? What is board thickness and size? Does it need to be fixtured for support thru out the process. Semi auto sc
Electronics Forum | Thu Aug 08 22:41:30 EDT 2019 | orbitcoms
The pick n place height for component was set to 1.4mm but I had not allowed for pin thickness. I added this (total height now 1.6mm) and I get very few solder bridges now. I might try 1.7 and see if it makes any further differnce
Electronics Forum | Tue Jul 26 19:03:40 EDT 2022 | aksaustin
It could be from your Deionized Mixed Beds. Resin on the mixed beds can have that smell if its bad or not flushed prior to use. Its a fishy/rotten eggs odor It would still happen if you dumped the water but didn't swap out the tanks and would smell
Electronics Forum | Wed Aug 07 18:25:52 EDT 2019 | slthomas
Normally if the package is defined properly I would expect your machine to place it correctly but we have some parts pushed right down to the pads. If the paste is centered, and the parts are centered, and you have obvious bridging potential coming
.gif)
