Electronics Forum | Thu Nov 08 16:26:41 EST 2012 | juggalo
Our facility is moving towards eliminating the need for carts completely by introducing conveyors. So far they have been set up before and after the wave. This has helped us reduce work in process inventory around the wave solders greatly.
Electronics Forum | Fri Apr 26 16:26:55 EDT 2013 | emeto
Hi, thanks for your answer. I was thinking to go even deeper by counting the hours the paste was exposed, but it probably doesn't make a lot of sense, especially considering the fact that my operators will add paste when the level goes too low. I wi
Electronics Forum | Tue Jul 30 16:26:54 EDT 2013 | jorge_quijano
It has about 50-60%, we do not have equipmet to get an accurate measurement, touch up is what we are doing for now.
Electronics Forum | Thu Feb 06 16:26:12 EST 2014 | alphatronique
HI SrTech yup i knot and it the good clip on the feeder i have event swap the whole clip whit the holding bard from one of my FC to the strange one and got same result so clip was not in cause and or the adjustment of the feeder
Electronics Forum | Wed Jan 31 09:16:26 EST 2018 | emeto
"...electro-chemical migration failures..." Come on Michael, You are totally selling it here.
Electronics Forum | Fri Oct 18 16:26:54 EDT 2019 | mendezt6
Swap part method??? Are you meaning swap the tool banks? The tabs on the tool bank look good, but if it’s tweaked slightly that would be hard to tell. Sorry, I’m just an operator/programmer. The person that did all this stuff left suddenly.
Electronics Forum | Fri Nov 13 19:16:26 EST 2020 | babe7362000
It has been awhile for me, but I do remember that sometimes the solder would fracture on the connector pins.
Electronics Forum | Wed Apr 26 16:26:20 EDT 2023 | cyber_wolf
Looking at both new SPI and AOI and recently found this out... So, should we be concerned about this ? I am told that this has not worked so well in the past.....
Electronics Forum | Fri Feb 24 21:16:26 EST 2023 | sarason
PCBSynergy supports the Juki RS-1R, it can be found here https://pcbsynergy.com sarason
Electronics Forum | Fri Jan 05 16:26:54 EST 2024 | mistrthou
I haven't used one, but KISS was bought out by Nordson, and the newest version of the KISS 103 is the Cerno 508.1. Their earlier Cerno's were almost identical to the KISS 103's. Something to keep in mind if you're used to programming that style.
