Electronics Forum | Thu May 29 13:02:57 EDT 2003 | designchain
Well that's one parameter and inadequate to specify either part. EPROMs aren't synchronous so specifying a clock rate doesn't really help - are you looking for a 50ns access time? 5V? 3.3V? What size memory? One-time programmable or UV eraseable or
Electronics Forum | Wed Apr 21 14:52:39 EDT 2010 | joeherz
I'm looking for a handheld barcode scanner that will handle high resolution 1D and 2D symbologies. Some of our 1D codes are down to 3.3mil lines and your average scanner can't reliably scan that resolution. I've used PSC and Wasp equipment before b
Electronics Forum | Fri Aug 12 09:07:23 EDT 2011 | rway
The rails are being sourced by the regulators. Rails, bus, you can use them interchangeably. As far as what voltage? I have no idea other than my assumptions listed above, but more than likely you will have +/-12V and 5V. Depending on the age of t
Electronics Forum | Wed Jan 18 06:22:23 EST 2012 | ngineer
I rang out the bases, the connectors are common (i.e from top to bottom, 1-1, 2-2, 3-3,4-4). I also measured voltage on the connectors. Front and back don't have any voltage, and the lights don't come on when I press the buttons. Left and Right ar
Electronics Forum | Thu Feb 28 11:02:31 EST 2013 | hegemon
1. Read the manual. It's pretty good, and an easy read. Most tech guys could read the manual and have a good start. 2. Call Mirtec, they should connect you with a local rep. who may or may not have some machine knowledge. They may want $ if the m
Electronics Forum | Fri May 08 23:28:28 EDT 2015 | alphatronique
Hi dont play whit cap substitute ,you may screw up the whole design ,many ceramic decoupling cap was sensitive to applied voltage and temperature specially true for X5R and Y5V type. so a 4V cap may have right capacity at 3.3V but a 6 volt cap
Electronics Forum | Tue Jul 19 18:05:31 EDT 2016 | davef
I'm not real clear on what you're looking to understand, but let me get things started ... IPC-A-610F - Acceptability of Electronic Assemblies, 7.3.3 Supported Holes – Wire/Lead Protrusion Minimum length: You need to be able to discern the compone
Electronics Forum | Tue Aug 01 11:23:56 EDT 2017 | OrHorti
We are using a custom made nozzle, designed for this particular LED. The dome of the LED is also custom made, the diameter of the lens at the base is 2.9mm while the substrate of the package is 3.3mm, so this gives about 0.2mm spacing between lens a
Electronics Forum | Mon Oct 15 15:29:19 EDT 2018 | emeto
You see, if you can optimize your product setup that will be the best. Back in the days, engineers used only standard values. For resistors for example I used to build boards having 100, 330, 470, 1k, 3.3k.....Sometimes that means you might end up wi
Electronics Forum | Thu Mar 12 15:06:07 EDT 2020 | kghadiya
Hello Folks out there. I am having trouble in Circuitcam when I pull reports. After processing all the prep and engineering work when I try to save/export any of the manufacturing related report I see the error. The error says that, "The Microso