Electronics Forum | Sun Jul 30 09:17:38 EDT 2006 | tonaxel
Hallo everybody, First of all I want to say that I�m verty impressed about the quality of this forum. I found it a couple of days before and it was already helpful for me. Thanks a lot to all of the editors and posters. I just started with smd and
Electronics Forum | Tue Jul 14 21:31:19 EDT 1998 | Wen-han Tan
We just have a use cp4 .I have a problem on transfering data between cp3 to cp4 .when I use the data for cp4 I can't have parts in correct location. Is that normal? or it's because that has a different vision system.if so.how can i do with it.the dat
Electronics Forum | Thu Sep 26 14:43:43 EDT 2002 | Jim M.
unsure of what solder spec. your working to?.IPC/EIA J-STD-001C, Section 9.2.4 clearly states dull, matte, gray or grainy appearing solders are accpetable depending on your process and if the acceptability of the neaxt paragraph is met.IPC 610 and J-
Electronics Forum | Tue Dec 17 11:01:24 EST 2002 | Tim Marc
Hello all, One of our PCB manufacturers coated a through hole connecters vias with solder mask. The only IPC references that comes close to describing this problem is 2.9.2 Registration to holes, and subsequent specification 6.3.1 PTH � Vertical fil
Electronics Forum | Fri Oct 07 12:13:39 EDT 2005 | jbrower
My experience with MYDATA has been good. Tech support has always answered my questions promptly and steered me in the right direction when I was at an impass. All in all the tech support department is great. Just my opinion and experiences. My curr
Electronics Forum | Wed Feb 28 07:30:26 EST 2007 | cyber_wolf
We recently scrapped our TP9-2U because of an issue similar to this. The X-axis would overshoot the pick and place positions. This particular machine(2U)only has 1 X motor. The UFP's and the MY machines have a small fine positioning motor that is on
Electronics Forum | Mon Jan 29 14:01:41 EST 2007 | realchunks
Well, they're all "HE"'s, which may be part of the problem (good one Dave) The customer "thinks" there may be a problem but has no actual proof. The part in question is a lug terminal. It's 0.145" by 0.175" and 0.020" thick. They couldn't "see" a
Electronics Forum | Tue May 07 13:51:51 EDT 2013 | shankar2013
acceleration is set to lowest. Ribbon cables were replaced, theta motor replaced. I also see a message pop up just after F-MOT1-26/156:MOVFI: MOTOR TIMEOUT / F-AXIS-182:C-AXIS NOT properly out when expected / 25v reads 3V. Now all these messages
Electronics Forum | Thu Jul 18 17:41:31 EDT 2019 | rgduval
The UFP was a designation for "ultra-fine-pitch"; but, for the most part, you should be able to get the same placements out of both machines. Anything 0402 or above can be mechanically centered. The UFP machine will lean on optical centering for .5
Electronics Forum | Fri Aug 20 12:44:27 EDT 1999 | ScottM
| IF anyone is placing 0402's with the Mydata tp-18 I would like to here how reliable it is(with these little buggers). | | | Thanks | | MD Cox | I've been placing them with a TP9-2U. You need to buy a new tip and a new feeder to accept taped co
