Electronics Forum | Fri Dec 11 13:06:54 EST 2020 | johndep7
I haven't, that is a good idea, I was reading about the chance of that earlier but I was not sure. The best way to eliminate is to bake the board?
Electronics Forum | Mon Nov 20 04:04:42 EST 2000 | Gyver
Sirs, Please do me a favor to answer the following questions, thanks a million! 1. Will the baking of BGA or PCB cause more oxidation before the SMT process? 2. What is the acceptable Life Time of solderability at customer site? The time that the sol
Electronics Forum | Mon Dec 29 09:10:22 EST 2008 | stepheniii
It takes time for the moisture to penetrate into the body. I think the 5 years of ambient would be more the culprit than washing the boards. Especially since you are baking them after wash. Get a few of the ICs and put them loose on a board and put
Electronics Forum | Fri Feb 18 09:41:44 EST 2000 | James Lewis
Has anyone seen or put together a good collection of proper handling procedures for components and PCB's? I realize a lot of it is no-brainer stuff, but I need some depth for a training class we are putting together. This would include ESD, Moisture
Electronics Forum | Fri Feb 18 09:41:44 EST 2000 | James Lewis
Has anyone seen or put together a good collection of proper handling procedures for components and PCB's? I realize a lot of it is no-brainer stuff, but I need some depth for a training class we are putting together. This would include ESD, Moisture
Electronics Forum | Fri Aug 28 23:32:39 EDT 1998 | Pete Sorenson
| Does anyone have any experience they are willing to share on Ag epoxy used as a copper through hole plating replacement? Was CEM3 used? | What are the limitations? | Thanks, | Steve I have used silver epoxy extensively for conductive bonding applic
Electronics Forum | Mon Jan 15 11:41:56 EST 2007 | davef
Questions are: * Does the component take solder when you dip it in the solder pot to test the solderability of the leads? * Can you get full barrel fill when wave soldering a bare board? * Is your flux reaching the top of the board through the hole b
Electronics Forum | Fri Dec 27 16:26:30 EST 2013 | davef
I expect to find the specification and measurement method for the bow & twist of an assembly to be on the assembly drawing. Comments are: * Expecting that an industry committee to write a bow & twist spec for an assembly they know nothing about is n
Electronics Forum | Tue Apr 11 10:30:46 EDT 2000 | Jeremy Smith
I am having a problem with some joints on a 100 pin pqfp and few different soics on one particular board. When viewed a 8x with a "Mantis" inspection scope the joints look as though they wetted to the ic leg but when probed the leg will pop loose.
Electronics Forum | Mon Feb 05 10:12:32 EST 2007 | slthomas
The use of booties isn't required per se, just considered a standard step necessary to reach the 10,000 target. You also need to vacuum (central vac system, NOT exhausting into the room) daily, mop weekly, have a one piece floor, blah, blah, blah....