Electronics Forum | Fri Oct 30 15:09:44 EST 1998 | ChungPark
| Dear all, | | What are your views on reworking BGA's? I mean, with the BGA going through reflow temperatures four times or more, and with a manual reballing process, wouldn't it raise up a few reliability issues? Would you consider not doing rew
Electronics Forum | Mon Apr 02 01:24:52 EDT 2007 | Haris
Dear all, I want to know the difference between the CSP and the BGA (I think there is only in the mesh pin difference). Secondly, if their solder balls have same dia, LxBxH are also same with the the manufacturing of the pin coating chemical elemen
Electronics Forum | Fri Apr 06 08:32:47 EDT 2007 | davef
Haris: On your soldering issues, we don't know the make-up of your component. We don't know the type solder balls on the component. We don't know the solder paste you plan to use. Your component and paste supplier are better sources for this type o
Electronics Forum | Sat Apr 07 00:41:35 EDT 2007 | Haris
Thank you all for giving me good knowledge.
Electronics Forum | Wed Feb 18 12:42:43 EST 2004 | babe
OK, if the sphere of the ball and the paste on the pad are both eutectic, 63/37 then the paste will reflow first causing a drop of the component, after which the spheres will reflow causing a double drop and a good intermettalic. You can see this by
Electronics Forum | Thu Apr 05 08:44:45 EDT 2007 | ck_the_flip
"Guest" is right, actually. CSP's are essentially BGA's, but typically the pitch and ball diameters are much smaller and in some cases, the pads of the CSP's can not be screen printed. If that's the case, you'd have to have flux-dip capabilities on
Electronics Forum | Tue Aug 22 03:04:07 EDT 2006 | PP
Any help/suggestion is much appreciated I am doing lots of BGA Reworks from a small uBGA with a few balls to a large BGA with over 1500 balls. The reworks have been done on SRT 1100 Series Machine for many years. SRT 1100 Machine is good for the c
Electronics Forum | Fri Jun 19 14:25:24 EDT 1998 | Earl Moon
| | Has anyone had experience with placing BGA on gold plated boards. I thought I read a while ago there was a problem with embrittlment causing cracked joints. If anyone has experience with this your feedback would be great. | | Mike | There has b
Electronics Forum | Fri Jun 19 13:40:25 EDT 1998 | Terry Burnette
| Has anyone had experience with placing BGA on gold plated boards. I thought I read a while ago there was a problem with embrittlment causing cracked joints. If anyone has experience with this your feedback would be great. | Mike There has been a
Electronics Forum | Wed Apr 04 18:27:53 EDT 2007 | Guest
Most CSPs are BGAs. Some are sent without bumps or balls. Thjos eneed to be bumped prior to processing for best results