Electronics Forum | Tue May 26 15:05:39 EDT 1998 | Justin Medernach
| | I know it's been covered before, but is there a newest, best way to reball BGA devices. Also, what's the latest rework methodology (pardon my linguistics). | | Earl Moon | Earl: We send the BGAs to a service "re-baller." Dave F | | PSI, 16833
Electronics Forum | Tue May 26 18:24:05 EDT 1998 | Earl Moon
| | | I know it's been covered before, but is there a newest, best way to reball BGA devices. Also, what's the latest rework methodology (pardon my linguistics). | | | Earl Moon | | Earl: We send the BGAs to a service "re-baller." Dave F | | | | P
Electronics Forum | Wed May 27 11:13:38 EDT 1998 | Justin Medernach
| | | | I know it's been covered before, but is there a newest, best way to reball BGA devices. Also, what's the latest rework methodology (pardon my linguistics). | | | | Earl Moon | | | Earl: We send the BGAs to a service "re-baller." Dave F | |
Electronics Forum | Wed Mar 15 09:53:58 EDT 2017 | rob
Hi Etimov, Understood that to us assembling parts that IPC is king, however it isn't neccesarily the bible for design engineers. We've had customers demand almost zero voiding, or had to use conductive epoxy to avoid it. For some of us solder joi
Electronics Forum | Fri Nov 23 16:32:05 EST 2007 | davef
There a several things you can do to prevent the solder wicking down the hole with the current design, and that's where you should focus. Cost goes up as you go down the list, but in neither case do you need to respin the board, have solder starvatio
Electronics Forum | Thu Nov 22 12:56:12 EST 2001 | tony_sauve
Thanks for the comments & suggestions. Here's some info garnered from a telecon w/the PCB Fab house: -the blind via's extend from layer 2-17...this was a revelation. The info from our customer was that the via's only extended down 2 layers. Did I men
Electronics Forum | Tue Apr 25 10:42:38 EDT 2006 | TMC
Almost all of the components on the bottom side are passives however, there are a couple of mBGA's and qfp's. I am aware that even if the components on the bottom do get reflowed, surface tension of solder will hold them in place. As far as IC's, w
Electronics Forum | Thu Jul 15 12:26:56 EDT 1999 | Earl Moon
| We have been encountering diminishing ball shear readings these past few weeks, despite the fact that we did not change any ball shear tester parameter. Our reflow parameters are also within spec limits. ( 210-220 deg C max temp. and 40-60 sec dwe
Electronics Forum | Thu Jul 15 15:55:41 EDT 1999 | nards penalosa
| | We have been encountering diminishing ball shear readings these past few weeks, despite the fact that we did not change any ball shear tester parameter. Our reflow parameters are also within spec limits. ( 210-220 deg C max temp. and 40-60 sec d
Electronics Forum | Mon Jan 10 11:08:39 EST 2005 | mrgman9999
We are having a problem with popcorning of a plastic BGA that has been under careful humidity control. We have had problems in the past and some have been related to too much trapped internal solvents from the die attach epoxy. We did a life time b