Electronics Forum | Sun Oct 04 20:55:44 EDT 2009 | phomann
Hi, I have a test pcb that came with my Yamaha YM84S machine. The board contains land patterns, fiducials, etc. The pyrpose of the board is to test the placement and vision systems in the machine. Does anyone provide the technical drawing of the bo
Electronics Forum | Fri Mar 11 10:00:22 EST 2005 | ???
Anybody out there know of a good (2nd) source to purchase single magnetic board supports used on quad/samsung machines. These are spring loaded and contact the underside of the board in the pick n place machine
Electronics Forum | Thu Oct 25 05:58:52 EDT 2007 | reypal
Is there a standard to specify how many times a profile board can be used? if No, then could I say that it depends on the actual board appearance (discoloration,delamination etc.) then it's time to replace a new one. Thanks in advance for sharing.
Electronics Forum | Fri May 29 07:17:30 EDT 2015 | kkay
We have a small board about 1" by .5" and it is .012" thick. It is in a 50 up panel. We have tried rat bites and v-score and we keep seeing delamination around the edges. Anyone have experience depaneling boards this thin?
Electronics Forum | Thu May 30 11:21:08 EDT 2019 | slthomas
100% visual inspection. If we test, then we retest (assuming this is a completed board). Also, if there is an accelerometer on board, we argue about whether or not we should replace it by default.
Electronics Forum | Mon Jul 01 04:35:22 EDT 2019 | sssamw
It depends on your product application requirement, normally should not drop off board for automotive. Even the dropped board pass function test in plant, it will have problem in its working environment.
Electronics Forum | Mon Jan 09 19:09:45 EST 2006 | Mike
Basically the same exact way as a much smaller board. The only difference is the profile. Most of our boards are 0.063" thick. Looks like you found your problem. If the edges of the board are cold relative to the rework site (high difference in t
Electronics Forum | Wed Aug 01 13:57:52 EDT 2012 | smtventasmex
Hi we have a problem with an Omniflow 10 he hood does not open, we have some zones failing, error messages, we change all the boards on the oven but not on the PC comm board, we saw than this board have damages and may be this will be the problem so
Electronics Forum | Mon Mar 12 08:00:14 EDT 2007 | rgduval
It sounds like you may be thinking of two different test methodologies. What is required? Bare-bard testing, to verify pcb fabrication? Or populated board testing, to verify manufacturing? If it's bare board testing, the fab house should advise a
Electronics Forum | Wed Dec 12 12:08:30 EST 2007 | realchunks
Yes, you can ask for scrap boards, buy Dummy boards/parts or engineer off past runs. For this cost, I would profile, profile, profile. I would make/buy a dummy board. If you don't have one this thick, glue/ adhesive/ bolt some scrap boards togeth