387 broken results

Electronics Forum: broken (Page 5 of 39)

Can I replace this broken micro switch and solder the new one like this ?

Electronics Forum | Mon Jul 06 21:16:59 EDT 2020 | raoult

Thanks guys for your help. Sorry for the pic quality, the device is so small I had to zoom a lot with my phone. The switch is a tactile one, the plastic body is missing, and what you can see in the center is where the contact is made : when the swit

Hanwha Samsung SM320 Failed to Start Mark5 SW - VME broken ?

Electronics Forum | Tue Dec 13 21:38:14 EST 2022 | duro

Stephen, there is one CMOS battery on PC board. I haven't check it, but time and date on PC is correct, so I guess it should not be problem. On VME controller is another CR2032 battery (based on VME datasheet it is for some RAM memory). That battery

Broken Ceramic SMT parts...

Electronics Forum | Fri Dec 26 16:04:33 EST 1997 | Michael Mihld

Hello all, I have experienced broken ceramic SMT parts. Most of the time, we have found fractured inductive beads. Once in awhile, we find broken Ceramic Caps. All parts we use are 1206 form factors and we use tape and reel... Michael

Broken Traces in PCB

Electronics Forum | Mon Aug 12 16:54:37 EDT 2002 | sasharm2

We are getting broken traces in PCBAs, any idea why. In addition, only few of the boards show this problem, hence I don't think it is an issue with the board manufacturer. thanks, SS

Broken Traces in PCB

Electronics Forum | Mon Aug 12 22:11:23 EDT 2002 | davef

I agree with what those other guys said. You problem description is vague. Please describe: * 'Broken' trace appearance * Where it is located * Process steps up to discovery * Board design * etc.

"connector fell off"

Electronics Forum | Sun Apr 04 11:17:09 EDT 2004 | wsanita

I feel the solder connections were fine. The anchor pads for this device on the board are covered by solder mask. So the leads of the connector take all the stress. The component was broken off and under a scope you can see the plating of each lead