Electronics Forum | Thu Oct 12 11:08:20 EDT 2000 | Fraser
Dave, Why on earth would you want to use a stepped glue stencil?. If you print slightly off contact the hight of your glue deposition will be roughly half the width of your adhesive aperture width so if you want a 10mil high deposit use a 20 mil ape
Electronics Forum | Tue Oct 03 07:48:52 EDT 2000 | steveZ
Had cheacked the archives but I didn't see much about their comparison: 1. Throughput 2. Rework Rate 3. Effect on Placement Accuracy 4. Cost (cheaper or more expensive in the long term?) Has anyone compared the above. Please help me.
Electronics Forum | Thu Oct 12 19:47:24 EDT 2000 | Dave F
Fraser: You're correct!!! We did our analysis on paste rather than glue and I missed that when changed things to respond.
Electronics Forum | Thu Oct 12 22:16:59 EDT 2000 | Dreamsniper
Hi Guys, I'd like to share this to all of you...you can start playing with the rests...Stated prices, if not indicated, are in Aussie $ or Singapore $. Stencil Printing Adhesive Pros a) Less Capital Equipment Cost (Short Term). In reality it is f
Electronics Forum | Fri Oct 13 13:44:03 EDT 2000 | Mike McMonagle
You can achieve a wide range of dot heights when stencil printing by using a polyimide stencil along with a .040 snapoff. Loctite has a system for this that they call Varidot, by varying the size of the apertures in combination with the .040 snapoff
Electronics Forum | Mon May 24 13:06:12 EDT 1999 | Deon Nungaray
| | | Any suggestions on how to maintain Adhesive dispensing nozzles??? They seem to plug up over night and it is starting to get on my nerves. We have tried leaving the nozzles in the machine, removing them and soaking in alcohol, blowing them o
Electronics Forum | Wed May 26 10:00:03 EDT 1999 | David Scott
| | | | | | | | | | | | Any suggestions on how to maintain Adhesive dispensing nozzles??? They seem to plug up over night and it is starting to get on my nerves. We have tried leaving the nozzles in the machine, removing them and soaking in alcoh
Electronics Forum | Tue May 25 11:31:57 EDT 1999 | Scott Cook
| | | | | | Any suggestions on how to maintain Adhesive dispensing nozzles??? They seem to plug up over night and it is starting to get on my nerves. We have tried leaving the nozzles in the machine, removing them and soaking in alcohol, blowing
Electronics Forum | Tue May 25 12:19:55 EDT 1999 | M Cox
| | | | | | | | | Any suggestions on how to maintain Adhesive dispensing nozzles??? They seem to plug up over night and it is starting to get on my nerves. We have tried leaving the nozzles in the machine, removing them and soaking in alcohol, bl
Electronics Forum | Thu Jul 20 13:58:47 EDT 2000 | Bob Willis
Well you can do both but why clinch the leads ? You are not referring to the SPOT process my friends at Camelot talked about some years back are you ? You can dispense paste but it�s a lot slower than printing. You can select a pin and dispense dire