Electronics Forum | Mon Mar 26 16:58:53 EDT 2018 | solderingpro
Is there anything stopping you from replacing the flat belt solution to a continuous running steel roller chain conveyor? - From there (depending upon board temperature) you should be able to buffer your boards in a vertical buffer station if neede
Electronics Forum | Fri Aug 28 12:05:12 EDT 2015 | davef
“The global automotive industry demands world class levels of product quality, productivity and competitiveness as well as continual improvement. To achieve this goal many vehicle manufacturers insist that suppliers are certified to the quality manag
Electronics Forum | Mon Jul 12 11:35:27 EDT 2004 | Pierre RICHARD
Here are some answers to my questions after a good research. I also added more definitions that could help understand this esoteric language used in assembly, specially surrounding fluxes and their use. In blue italics are comments and extracts from
Electronics Forum | Fri Nov 18 12:35:15 EST 2011 | rway
As the article eludes to, you still need probe access to measure the pins with TestJet. One thing I wanted to add was the use of JTAG for use with Boundary Scan. Certain devices have JTAG capability, but not all JTAG devices are Boundary Scan compa
Electronics Forum | Fri Mar 17 10:16:10 EST 2006 | Chunks In Cebu
Just thought of something while on the beach. We made a paste change several years ago when we installed another surface mount line. At around that same time, our maint. crew changed chain oil and about 2 months later changed when they oiled the ch
Electronics Forum | Thu May 14 10:00:14 EDT 2015 | swag
I like MpM personally - run forever and programming is easy and leads you through it. It's hard to miss a step of programming with MpM software. DEK's a little harder (for me) but still very nice controls. The pluses of DEK - DEK has a high freque
Electronics Forum | Mon Mar 20 09:08:42 EST 2006 | mapell
AR Sounds like dirty chains... couple ways to check... Pull off the drive chain for the conveyor. Place a wrench on the (unload end) drive shaft and spin, if it is a bit tough.. dirty rails. Also look at load end of chains. The chain goes low and w
Electronics Forum | Thu Mar 10 12:19:17 EST 2005 | rlackey
Borrow a large hungry dog (or wolf if local wildlife permits) & chain it up in the corner of the office when the salesman comes in. Then look over at it repeatedly whilst talking about your requirements. Feel free to leave him alone for a while...
Electronics Forum | Fri Nov 02 14:46:18 EDT 2012 | ericrr
So how does this (lead free paste Sn42/Bi58) solder compare with the Sn-Ag-Cu (Tin-Silver-Copper) combination which does not flow as well (in the oven), needs higher oven temperature, (that can be adjusted by reducing the oven chain speed) and cost m
Electronics Forum | Fri Feb 22 12:02:24 EST 2008 | soudomphong
I have been searching for a compatible high temp chain oil other than Tribol 1421/SG due to cost cutting, which is what electrovert is recommending. I was wondering if anybody can tell me beside Tribol 1421/SG. What other brand out there that is come