Electronics Forum | Tue Oct 27 10:40:32 EST 1998 | Greg Curler
| I know that this not surface mount, but many of us have to perform multipule duties. Can anyone give me some information on this I am having problems getting relibility | getingthe heat seal ribbon to make consistant electrical contact. | Any help
Electronics Forum | Tue Jan 07 09:51:27 EST 2003 | Mr. Fuller
I am looking for some feedback from anyone who has used a Universal GSM for placement of paste-in-hole (PTH) connectors. The connectors in question are simply 8-pin, (non-press-fit), header connectors. I understand that a special 'chuck' may be requ
Electronics Forum | Thu Mar 14 10:51:12 EST 2002 | Chuck
I have a trace about 0.060' wide and I need to place a chip resister on it. * What is the best tool to use to cut the trace without slipping and scratching other traces or masking around it? I have used X-Acto #11,#16,#24 blades without success.
Electronics Forum | Thu Jul 14 19:05:24 EDT 2005 | valuems
Hi Sounds like a good idea, will get back with you. We are looking for as much feed back as possible. We have about 11 years experience on MPM's and we have several areas that we already have on our list. Have thought about putting the tac-tile on
Electronics Forum | Tue Dec 20 07:58:32 EST 2005 | dwensker
Thank you all for your info. Our problem is fixed. We did as you mention: - chuck set correctly on the collers, Wide jaw Soft spring & Narrow jaw hard spring - make the pick-place soft - slow down the speed controllers for both descent and ascent r
Electronics Forum | Mon Jul 10 12:38:19 EDT 2006 | fredericksr
Hello All, Has anyone tested the effectiveness of any process to remove lead from tinned soldering irons to RoHS acceptable levels? We have been dedicating new tips for RoHS assembly, but as our RoHS product line increases it will be important
Electronics Forum | Thu Oct 07 22:32:16 EDT 2010 | jeffr
I cannot offer a manual as a PDF, however I do have printed copies that could be photocopied. To be honest.. the manuals are little help as they are very Jap-English, anyway the Yamaha/Philips 66 is a simple machine that requires no real program trai
Electronics Forum | Fri Jun 13 08:00:57 EDT 2014 | sargeredarmy01
Haha, I can assure you sir I cannot see Russia from my house. Will admit that I do have some form of connection with the USAF. The error that comes up is a cycle alarm and a chuck set. I have attached a reference image of the machine screen. I als
Electronics Forum | Fri Jun 13 11:28:40 EDT 2014 | jimmyboz
There is a small cylindrical sensor on the air cylinder that that actuates the chuck. I can't remember if there are one or two. Its (they) are about 4mm x 20mm and I think (it) they have a signal light. Make sure it is mechanically working properl
Electronics Forum | Wed Jan 06 11:05:13 EST 2021 | greezmky
Thank you rtmitchell, being unfamiliar with the system, I missed that the end is slightly nicked. I pulled a dog out of a machine that has been cannibalized, I verified that it was straight and not nicked, and installed it in our production line mach