Electronics Forum | Tue Jan 30 15:12:56 EST 2024 | oxygensmd
We have 3 of them. E5 (2000), X5 (2006), X4 Proffessional (2012). All of them can handle our requirements, even E5 have the requested accuracy. X5 have disk PCB clamping which really nice for the operators and X4Prof have SPS (3-stage) witch pneumati
Electronics Forum | Tue Oct 13 16:26:26 EDT 1998 | Earl Moon
| | We suffered our first blood letting because of razor sharp edge clamps (DEK 265LT) and operator giving it the finger. While positioning magnetic tooling pins, one of our best slipped and really sliced off a part of his main digit. This will impac
Electronics Forum | Tue Oct 13 12:58:18 EDT 1998 | Justin Medernach
| We suffered our first blood letting because of razor sharp edge clamps (DEK 265LT) and operator giving it the finger. While positioning magnetic tooling pins, one of our best slipped and really sliced off a part of his main digit. This will impact
Electronics Forum | Wed Oct 14 05:32:24 EDT 1998 | Tony B
| | | We suffered our first blood letting because of razor sharp edge clamps (DEK 265LT) and operator giving it the finger. While positioning magnetic tooling pins, one of our best slipped and really sliced off a part of his main digit. This will imp
Electronics Forum | Fri Dec 31 20:04:10 EST 1999 | Stu Leech
At Altos Engineering we do a lot of process testing of our TVP drying systems for demoisturizing. We store test devices in metalized vapor-proof bags. Instead of heat sealing, we use Croc-Clamps to seal the bags. They have been tested for sealing eff
Electronics Forum | Tue Oct 13 09:08:54 EDT 1998 | Earl Moon
We suffered our first blood letting because of razor sharp edge clamps (DEK 265LT) and operator giving it the finger. While positioning magnetic tooling pins, one of our best slipped and really sliced off a part of his main digit. This will impact hi
Electronics Forum | Tue Nov 23 15:59:51 EST 2004 | RCanten
I have seen some crazy placement problems that I just couldn't figure out in the past and several have come down to boards moving in the clamp. I would double check to make sure you are clamping secure enough and slow your table speed down and see if
Electronics Forum | Thu Aug 25 11:15:16 EDT 2005 | dougs
do you mean the board support pins? generally anytime i've set these up i've just set the height as i've went, i put the pin under the board, with the board clamped, and move it up until it touches the board and set it there. you just need to make
Electronics Forum | Tue Oct 31 15:45:17 EST 2006 | dman97
Does any one know where to buy spare parts for an MPM UP1500, other than from Speedline themselves? I need to buy replacement foil clamps for my machine, but MPM wants $393 each! It is just a piece of foil, a sharp one at that. I ain't going to spend
Electronics Forum | Tue Mar 06 08:33:40 EST 2007 | cardinal
You can get a topside edge-clamping system to fit your AP HI E printer from Gridlok. They make a universal tooling system and topside edgeclamping system for the AP series and UP 2000 series printers. The Y snugger tooling option when ordered with t
