Electronics Forum | Tue Jul 16 13:08:24 EDT 2013 | ericrr
I seem to of slipped into a mighty giant suction cup, and every day is the same. Now take yesterday as I was making a sample the start of run board, we have run many times. it got halfway placing diffused LED's 3216 (about 1207 size) then is stoppe
Electronics Forum | Sat Aug 28 14:16:18 EDT 1999 | JohnW
Doug, Have you tried running the boards at an angle to the wave of between 15 - 30 degree's ? I've done this on a few boards to eliminate short's and I believe it will work on your problem very sucessfully. Best thing to do is get your wave solder c
Electronics Forum | Tue Jun 13 16:53:35 EDT 2017 | sean87
For many moons, I have used IPA for our cleaning > tanks within out DEK systems. Now we have a new > engineering team and he would like to try a > stencil cleaning solution (DEK PRO XF). Can > everyone tell me there pros and cons of using > each
Electronics Forum | Tue Aug 31 08:10:38 EDT 1999 | Brian Conner
| I am building a board with T1/34 LED's in a 10X10 array there are 12 arrays in a panel. The LED's are body to body in the array, .1 spaced. The LEDS have been autoinserted on a Universal RAD III, so they are cut and clinched. The trouble I am havin
Electronics Forum | Wed Jul 09 12:00:25 EDT 2014 | bobpan
You have a rather old machine that you are running....now realizing this you need to check some things. 1. Clean the scales in the x and y direction. On some of the encoders there is an led to see if its reading correctly....Usually it turns green b
Electronics Forum | Wed Dec 04 12:42:04 EST 2019 | dunks
We currently use Kester's ep256 as well and it seems to be a bit more grainy than one would expect from lead, especially if the temperature is too low. That paste says it's specialty is being robust over a wide range of profiles and stencil conditio
Electronics Forum | Wed Apr 30 19:55:21 EDT 2003 | Mike Konrad
In all likelihood, you may not be leaving flux on the board rather you may be leaving saponifier on the board. Improper rinsing is a leading cause of cleaning related board failures. The problem with some inline cleaning systems (especially old o
Electronics Forum | Fri Jul 30 09:43:44 EDT 1999 | C.K.
| We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. | The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is that after
Electronics Forum | Mon Jul 26 10:25:12 EDT 1999 | Boca
| | We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. | | The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is that a
Electronics Forum | Mon Jul 26 14:14:51 EDT 1999 | Steve Gregory
| | | We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. | | | The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is th