Electronics Forum | Mon Sep 20 09:02:34 EDT 1999 | Wolfgang Busko
| Hi all, | | We have a little discussion here about the suitable flux for a certain process, as all of us are beginners we need your advice. | | We are producing VGA cards and mother boards for PC's all components to be wave soldered are TH, the S
Electronics Forum | Mon Sep 20 17:36:46 EDT 1999 | Dave F
| | | Hi all, | | | | | | We have a little discussion here about the suitable flux for a certain process, as all of us are beginners we need your advice. | | | | | | We are producing VGA cards and mother boards for PC's all components to be wave so
Electronics Forum | Mon Sep 20 17:20:08 EDT 1999 | Earl Moon
| | Hi all, | | | | We have a little discussion here about the suitable flux for a certain process, as all of us are beginners we need your advice. | | | | We are producing VGA cards and mother boards for PC's all components to be wave soldered are
Electronics Forum | Mon Sep 20 14:46:03 EDT 1999 | Dave F
| Hi all, | | We have a little discussion here about the suitable flux for a certain process, as all of us are beginners we need your advice. | | We are producing VGA cards and mother boards for PC's all components to be wave soldered are TH, the S
Electronics Forum | Tue Sep 21 07:47:31 EDT 1999 | Wolfgang Busko
| | Hi all, | | | | We have a little discussion here about the suitable flux for a certain process, as all of us are beginners we need your advice. | | | | We are producing VGA cards and mother boards for PC's all components to be wave soldered are
Electronics Forum | Thu Aug 28 11:02:28 EDT 2008 | omid_juve
we have two similar pcb from two different pcb manufacturer one of them passed the wave soldering without any short circuit and residue and another one passed it with many residue . don`t you think that the type of solder mask from these two pcb manu
Electronics Forum | Fri Aug 29 14:57:24 EDT 2008 | wavemasterlarry
What, Listen. Everyone know wave solders catch fire from time to time. I've only been a part of these fires a coupel times. Less than the number of fingers on my hands, so I don't think it's any different then anyone elses. Plus I havn't pulled o
Electronics Forum | Wed Jun 16 08:56:34 EDT 1999 | Vic Lau
Do anyone have any experience on assembling high frequency product, 1.8GHz or 2.4GHz. In our production line, we manufacture 1.8GHz product with using no clean paste (RMA type) for reflow and no clean wire for rework. In our functinal test,either a
Electronics Forum | Sat Aug 26 12:26:57 EDT 2000 | Ramon I Garcia C
Hi friends: I have a problem in the process of one PCB, I have a lot of insuficients of solder in top of the board, this pcb already was working good, but sudenly began there isn't flow thru hole, I ran the profile and it was ok, if I inmerse i
Electronics Forum | Tue Nov 02 08:36:51 EDT 2010 | rgduval
Michelle, Our experience with no-clean solder pastes has been that water washing a mis-print is a bad idea. We've found that DI water does not do a sufficient job removing the no-clean paste (the same goes for stencils). Instead, we have washed no
